Question is ⇒ The power gain of a half-wave dipole with respect to an isotropic radiator is, Options are ⇒ (A) 2.15 db, (B) 3 db, (C) 4.15 db, (D) 6 db, (E) , Leave your comments or Download question paper.

Question is ⇒ The power gain of a half-wave dipole with respect to an isotropic radiator is, Options are ⇒ (A) 2.15 db, (B) 3 db, (C) 4.15 db, (D) 6 db, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The power gain of a half-wave dipole with respect to an isotropic radiator is
A.	2.15 db [Correct Answer]
B.	3 db [Wrong Answer]
C.	4.15 db [Wrong Answer]
D.	6 db [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit shown the voltage V_s has a phase angle of __________ with respect to V_{L120°
60 °
-90 °
0°}

⇒ In binary data transmission DPSK is preferred to PSK because
a coherent carrier is not required to the generated at the receiver
for a given energy per bit, the probability for zero is less
the 180° phase shifts of the carrier
more protection is provided against impulse noise

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
y + 0.57x = 9.7558
y - 0.57x = 9.758
033y + x = 6.335
0.33y - x = 6.335

⇒

Assertion (A): In simplifying block diagram the product of transfer functions in feed forward direction must remain the same.

Reason (R): In simplifying block diagram the product of transfer functions around a closed loop must remain the same.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If an amplifier with gain of - 100 and feedback of β = - 0.1 has a gain change of 20% due to temperature the change in gain of the feedback amplifier will be
0.0002
0.02
0.001
0.0001

⇒ When an SCR is in forward blocking mode, the applied voltage
appears across only one junction
is equally shared by two junctions
is equally shared by three junctions
may appear across one or more junctions

⇒

Assertion (A): Microstrip is very commonly used in microwave integrated circuits.

Reason (R): Microstrip has an easy access to the top-surface so that active and passive discrete components can be easily mounted.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The slope of log-magnitude asymptote changes by - 40 dB/ decade at a frequency ω₁. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
a pole or zero at origin is present

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ Which of the following microphones has an inbuilt amplifier?
Condenser
Moving coil
Ribbon
Carbon

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about
50 or more
10 or more
25 or more
200 or more

⇒ DMA stands for direct memory access.
TRUE
FALSE

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒ A Wien bridge oscillator uses
negative feedback
positive feedback
both negative and positive feedback
none of the above

⇒ Pick the odd one out
PPM
PDM
PWM
PLM

⇒ Figure below shows D type Flip-Flops connected as shift register, then outputs Q_D, Q_C, Q_B, Q_A are given
1 and 2 only
2 and 3 only
1, 2 and 3
none of these

⇒

Match the following:

	List I (Circuit)		List II (Characteristics)
A.	Darlington pair	1.	uses pnp and npn transistors used as power amplifier
B.	CB amplifier	2.	Voltage gain nearly 1 and high input impedance
C.	Cascade amplifier	3.	low input impedance used for high frequency isolation

A-1, B-2, C-3
A-2, B-3, C-1
A-2, B-1, C-3
A-3, B-1, C-2

⇒ The radiation resistance of a resonant long wire antenna of half wavelength (λ/2) is given
73 Ω
120 p
377 Ω
7.3 Ω

⇒ Unit of e is __________ .
coulomb/newton-metre
coulomb²/newton-metre
Farad/metre
Farad²/metre

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ Which of the following is an oscillator with best frequency stability?
Crystal oscillator
Clapp oscillator
Phase shift circuit
Multivibrator

⇒ If both the emitter base and the collector base junctions of a bipolar transistor are forward biased, the transistor is in the
active region
saturated region
cut off region
inverse mode

⇒

Match the following:

	List I		List II
A.	Reflex Klystron	1.	High efficiency
B.	Dielectric loaded wave guide	2.	Slow wave structure
C.	TWT	3.	Cross field device
D.	Multi Cavity Klystron	4.	Oscillator

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2

⇒ At room temperature the number of conducting electrons in an intrinsic semiconductor
is almost equal to the number of valence electrons
is about half the number of valence electrons
is small as compared to the number of valence electrons
is a very small fraction of the number of valence electrons

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ Which of following antenna does not depend upon the frequency?
Log-periodic
Parabolic
Conical
All of the above

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling