Question is ⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is, Options are ⇒ (A) 0.6, (B) 0.25, (C) 4, (D) 0.36, (E) , Leave your comments or Download question paper.

Question is ⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is, Options are ⇒ (A) 0.6, (B) 0.25, (C) 4, (D) 0.36, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
A.	0.6 [Correct Answer]
B.	0.25 [Wrong Answer]
C.	4 [Wrong Answer]
D.	0.36 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The relaxation time of electrons in a metal is of the order of
10^-6 secs
10^-10 secs
10^-14 secs
10^-20 secs

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒

Assertion (A): Direct coupled amplifiers are rarely used

Reason (R): Direct coupled amplifiers suffer from the disadvantage of drift

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): The dual of a circuit can be drawn by window-dot method.

Reason (R): The principle of duality is of great help in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a varistor, as the voltage increases beyond a certain value, its resistance
rapidly increases
rapidly decreases
becomes negative, i.e., varistor goes into negative resistance region
none of these

⇒ Electric lines of force do not cross each other because
the lines of force mutually repel each other
the lines of force emanate from a point charge
the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible
none of the above

⇒ Which of the following finds application in pocket calculators?
TTL
CMOS
ECL
Both (a) and (c)

⇒ Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?
Measurement of unknown voltage
Measurement of resistance
Measurement of unknown current
Calibration of voltmeter

⇒ The main application of enhancement mode MOSFET is in
amplifier circuits
oscillator circuits
switching circuits
all of the above

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ 9's complement of 12₁₀ is
21₁₀
87₁₀
78₁₀
76₁₀

⇒ High speed logic circuits use
pulses with very small width
pulses with very large width
pulses whose width is neither small nor large
either (b) or (c)

⇒ The mean life time of carrier may range from 10^-9 seconds to hundreds of μ-seconds.
TRUE
FALSE

⇒ Which of the following array names in Fortran 77 is invalid?
A(6)
A(R)
A(I)
A(N)

⇒ SCR turns of from conducting state to blocking state on
reducing gate current
reversing gate voltage
reducing anode current below holding current value
applying ac to the gate

⇒ Which one of the following is a cut set of the graph in the given fig
1, 2, 3, and 4
2, 3, 4, and 6
1, 4, 5, and 6
1, 3, 4, and 5

⇒

Assertion (A): In a series resonant circuit current is maximum at resonance.

Reason (R): The inductive and capacitive reactances are equal.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ The impurity commonly used for realizing the base region of a n-p-n transistor is
gallium
indium
boron
phosphorus

⇒

Assertion (A): In a BCD to 7 segment decoder the number of outputs active at one time is always the same.

Reason (R): A decoder can be used to interface BCD input to LED display.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In which of the following frequency bands are the standard AM radio broadcast stations?
MF
HF
VHF
UHF

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ In figure readings of the two voltmeters shoul
100 V on each meter
200 V on each meter
150 V on V₁ and 50 V on V₂
50 V on V₁ and 150 V on V₂

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ The following properties are associated with ferroelectric materials:

Its susceptibility is negative.

The susceptibility is expresse
1 only
1 and 3
2 only
1, 2 and 3