Question is ⇒ The polynomial P (s) = (s - 1) (s2 + 1) (s + 2) (s + 3) is, Options are ⇒ (A) Hurwitz but not strictly Hurwitz, (B) not Hurwitz, (C) strictly Hurwitz, (D) anti/Hurwitz, (E) , Leave your comments or Download question paper.

Question is ⇒ The polynomial P (s) = (s - 1) (s2 + 1) (s + 2) (s + 3) is, Options are ⇒ (A) Hurwitz but not strictly Hurwitz, (B) not Hurwitz, (C) strictly Hurwitz, (D) anti/Hurwitz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The polynomial P (s) = (s - 1) (s² + 1) (s + 2) (s + 3) is
A.	Hurwitz but not strictly Hurwitz [Wrong Answer]
B.	not Hurwitz [Wrong Answer]
C.	strictly Hurwitz [Correct Answer]
D.	anti/Hurwitz [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The effect of negative feedback on distortion and bandwidth because
both are decreased
both are increased
distortion is reduced and bandwidth is increased
distortion is increased and bandwidth is decreased

⇒ The contents of the program counter after the call operation wil
(30F0)_H
(40F0)_H
(50F0)_H
(60F0)_H

⇒ A JFET
is current controlled device
has low input resistance
has high gate current
is a voltage controlled device

⇒ The dual of the function A(BC + BC + BC) is
A + (B + C) (B + C) (B + C)
A (BC + BC + BC)
C(BA + CA + CA)
ABC + ABC + ABC

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒ The most commonly used transistor amplifier circuit is
CB
CC
CE
CE or CC

⇒ A 6 bit ladder A/D converter has input 101001. The output is (assume 0 = 0 V and 1 = 10 V)
4.23
6.41
5.52
9.23

⇒ In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE

⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open

⇒ CW Doppler radar is capable of giving accurate measurements of relative velocities.
TRUE
FALSE

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ The stack pointer holds the address of the desired memory location.
TRUE
FALSE

⇒ Which of the following READ statements is correct in FORTRAN 77?
READ *, HONEY (I), I = 1, 5
READ *, (HONEY (I), I = 1, 5)
READ * HONEY I, I = 1, 5
READ HONEY I, I = 1, 5

⇒ Which of the following is not a valid variable name in C?
p_ce1
1p_ce
p1_ce
p _ced

⇒ A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be
0.25 Ω
0.5 Ω
1.25 Ω
2.5 Ω

⇒ An antenna is synonymous to a
generator
transformer
regulator
reflector

⇒

Assertion (A): A ballistic galvanometer is used to measure charge.

Reason (R): In a flux meter, the damping is large.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Match the following:

	List I		List II
A.	TV	1.	1 kHz
B.	Radio	2.	3 kHz
C.	Telephony	3.	9 kHz
D.	Telegraphy	4.	5 MHz

A-4, B-1, C-2
A-4, B-3, C-2
A-2, B-1, C-3
A-1, B-2, C-3

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I		List II
A.	Anderson Bridge	1.	Low resistance
B.	Kelvin Bridge	2.	Medium resistance
C.	Schering Bridge	3.	Inductance
D.	Wheatstone Bridge	4.	Capacitance

A-4, B-2, C-3, D-1
A-3, B-2, C-4, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ The electrolyte in nickel cadmium cell is dilute potassium hydroxide.
TRUE
FALSE

⇒ In the circuit of figure for sinusoidal input the waveform of the output will be as show
figure A
figure B
figure C
figure D

⇒ A half adder adds __________ bits and a full adder adds __________ bits.
two, three
three, four
four, six
two, four

⇒ The p mode of operation of magnetron signifies that
the phase difference between adjacent anode poles is p radians
the phase difference between adjacent anode poles is a multiple of p radians
the total phase shift around the periphery is p radians
none of the above

⇒ D/A converters are generally
weighted resistor network
binary ladder network
either (a) or (b)
neither (a) nor (b)

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ The name field effect is related to the __________ layers of a JFET.
depletion
drain
source
gate

⇒ Which of the following operation are performed on linear queues?

Testing a linear queue for underflow
Enqueue operation
Dequeue operation
Testing a linear queue for overflow.

Select the correct answer using the codes given below the lists
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2, 3 and 4