Question is ⇒ The poles and zeros of a positive real function, Options are ⇒ (A) may lie any where in <i>s</i> plane, (B) may have positive or negative real part, (C) must occur in conjugate pair, (D) must have either negative or zero real part, (E) , Leave your comments or Download question paper.

Question is ⇒ The poles and zeros of a positive real function, Options are ⇒ (A) may lie any where in <i>s</i> plane, (B) may have positive or negative real part, (C) must occur in conjugate pair, (D) must have either negative or zero real part, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The poles and zeros of a positive real function
A.	may lie any where in s plane [Wrong Answer]
B.	may have positive or negative real part [Wrong Answer]
C.	must occur in conjugate pair [Wrong Answer]
D.	must have either negative or zero real part [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following rules for constructing variable names in C

It can have alphabets, digits or underscores but no other special character.
The maximum number of characters is 8.
The first character may be an alphabet or digit but not underscore.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In digital circuits Schottky transistors are preferred over normal transistors because of their
lower propagation delay
lower power dissipation
higher propagation delay
higher power dissipation

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ To draw dc equivalent circuit for a CE amplifier circuit we should
Reduce all ac sources to zero
Open all capacitors
Reduce all ac sources to zero and open all capacitors
Reduce all ac sources to zero and short all capacitors

⇒ A 16:1 multiplexer has 4 select input lines.
TRUE
FALSE

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ At a temperature of 7 K, lead is a superconductor.
TRUE
FALSE

⇒ Which of the following is not a non-linear element?
Transistor
Heater coil
Diode
Electric arc with unlike electrodes

⇒

Match the following:

	List I		List II
A.	Copper	1.	produces discrete energy level just above valence band
B.	Rubber	2.	produces discrete energy level just below conduction band
C.	Antimony	3.	large forbidden gap
D.	Boron	4.	valence and conduction bands overlap

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ Satellite communication uses frequencies in the range of
3 to 6 GHz
3-10 MHZ
10-50 GHz
100-200 GHz

⇒ The number of free electrons in acceptor atom is
1
2
3
4

⇒ If each stage has a gain of 10 dB and noise figure of 10 dB, then the overall noise figure of a two stage cascade amplifier will be
10
1.09
1
10.9

⇒ Ac signals are given to both inverting and non-inverting terminals of an op-amp. When will the output maximum
when the phase difference between the inputs is 0°
when the phase difference between the inputs in 90°
when the phase difference between the inputs is 180°
when the phase difference between the inputs is 0 or 180°

⇒ Consider the following statement : If a network has an impedance of (1 - j) as a specific frequency, the circuit would consist of series

R and C
R and L
R, L and C

Which of the statement are correct?
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ The S (sign) flag is set when the contents of accumulator become negative during an operation.
TRUE
FALSE

⇒ Companding is used
to overcome quantising noise in PCM
in PWM receivers to reduce impulse noise
to protect small signals in PCM from quantising noise
none of the above

⇒ In most transistor the collector region is made physically larger than the emitter region
for dissipating heat
to distinguish it from other regions
as it is sensitive to ultraviolet rays
to reduce resistance in the path of flow of electrons

⇒ A dielectric of relative permittivity ∈_r is subjected to a homogeneous electric field E. The dipole moment P per unit volume is given by
P = constant
P = ∈₀ E
P = ∈₀(∈_r - 1) E
P = ∈_r E

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in
registers
cache memory
primary memory
mass storage

⇒

Assertion (A): If contents of F register in 8085 are 01010001, it means S = 0, Z = 1, AC= 1, P = 0 and CY = 1.

Reason (R): When an instruction is called from memory, the op. code of instruction is stored in instruction register.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Karnaugh map is used to
minimise the number of flip flops in a digital circuit
minimise the number of gates only in a digital circuit
minimise the number of gates and fan in a digital circuit
design gates

⇒ The total area under the probability distribution curve is
1
0
depend upon curve equation
∞

⇒ In grid bias modulation system the power required for modulating amplifier
is negligibly low since grid is negative
is large as compared to that for plate modulation
is almost the same as compared with plate modulation
is small as compared to that for plate modulation

⇒ A fully controlled bridge converter can operate in quadrants
1
1 and 2
1 and 3
1 and 4

⇒ Which junction has least junction capacitance?
Alloy
Grown
Diffused
Point contact

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒

Assertion (A): A GTO circuit is more compact than SCR circuit

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct