Question is ⇒ The pole zero plot of the given figure is, Options are ⇒ (A) non-minimum phase function, (B) minimum phase function, (C) all pass function, (D) either (b) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ The pole zero plot of the given figure is, Options are ⇒ (A) non-minimum phase function, (B) minimum phase function, (C) all pass function, (D) either (b) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The pole zero plot of the given figure is
A.	non-minimum phase function [Correct Answer]
B.	minimum phase function [Wrong Answer]
C.	all pass function [Wrong Answer]
D.	either (b) or (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ In Schottky TTL, a Schottky diode is used for
forming the gate
connecting the resistor
clamping of the basic collector junction
none of the above

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ An ac network has a power factor of 0.8 leading if the applied wave is of fundamental frequency. If the applied wave contains third and fifth harmonics, the overall power factor will be
0.8 leading
less than 0.8 leading
more than 0.8 leading
0.8 leading or more

⇒ Beamwidth of an antenna depends upon
shape of radiation pattern
dimensions
wavelength
all of the above

⇒ The maximum power output of a standard A earth station over the total band allocated to satellite communication is about
0.5 kW
8 kW
20 kW
50 kW

⇒ If we connect two silicon unilateral switches in anti- parallel we get
SCR
SBS
SCS
UJT

⇒ If a short line is terminated in characteristic impedance it behaves as an infinite line.
TRUE
FALSE

⇒ The capacitors C₁, C₃, C₄ and C₅ have a capacitance of 4 μF each and the capacitor C₂ has a capacitance of 10 μF. The effective capacitance (in μF) between the points X and Y will
4 μF
6 μF
3 μF
8 μF

⇒ Typical value of power consumption of TV transmitter is
0.5 kVA
2 kVA
50 kVA
1000 kVA

⇒ In a T flip-flop the output frequency is
same as input frequency
half of I/p frequency
double the input frequency
none

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ Compared to bipolar junction transistor, a JFET has
lower input impedance
high input impedance and high voltage gain
higher voltage gain
high input impedance and low voltage gain

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE

⇒

Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar

⇒ In a shield helix
the spacing between adjacent turns is very large
the spacing between adjacent turns approaches zero
the spacing between adjacent turns approaches zero and wire thickness approaches zero
the spacing between adjacent turns is very large wire thickness approaches zero

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒ A parabolic antenna produces a radiation pattern which is
circularly polarized
highly directional
omnidirectional
linearly polarized

⇒

Assertion (A): The hybrid p model of a transistor can be reduced to h parameter model and vice versa.

Reason (R): Hybrid p and h parameter models are interrelated as both of them describe the same device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The emitter follower steps up the impedance by a factor of
a
β
a β
a/β

⇒ An infinite ladder is constructed with 1 Ω and 2 Ω resistors shown be
8.18 A
0
0.375
can't determined

⇒ An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
sine wave
square wave
triangular wave
(a) or (c)

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ India's first three-axis stabilised geostationary communication satellite is
Rohini
Aryabhatta
Apple
Bhaskara