Question is ⇒ The pole of a reactive function, Options are ⇒ (A) lie on jω axis only, (B) lie on negative real axis only, (C) may lie anywhere on s plane, (D) lie on jω axis or on negative real axis, (E) , Leave your comments or Download question paper.

Question is ⇒ The pole of a reactive function, Options are ⇒ (A) lie on jω axis only, (B) lie on negative real axis only, (C) may lie anywhere on s plane, (D) lie on jω axis or on negative real axis, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The pole of a reactive function
A.	lie on jω axis only [Correct Answer]
B.	lie on negative real axis only [Wrong Answer]
C.	may lie anywhere on s plane [Wrong Answer]
D.	lie on jω axis or on negative real axis [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a tape recorder the erase head is
engaged during playback but disengaged during recording
engaged both during recording and playback
disengaged both during recording and playback
engaged during recording but disengaged during playback

⇒ The circuit consisting of two transistor connected in series with the d.c. supply voltage is called
push pull
differential pair
stacked V⁺
complementary symmetry

⇒ An AND gate has four inputs. One of the inputs is low and other inputs are high. The output
is low
is high
is alternately low and high
may be high or low depending on relative magnitudes of inputs

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ When a material becomes a superconductor, its resistivity becomes
very small
zero
about 10% of normal value
about 20% of normal value

⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
0 to 200 Ω
200 - 400 Ω
200 Ω and above
400 Ω and above

⇒ Consider the following functions

It detects the AM video carrier IF so as to produce the video signal
It produces and separates out the inter carrier sound IF of 5.5 MHz
It amplifies the video signal
It amplifies the audio signal

The video detector in a colour TV performs which of the above functions
1, 2 and 3
1, 2, 3 and 4
1 and 2
1, 2 and 4

⇒ Schottky clamping is resorted to in TTL gates
to reduce propagation delay
to increase noise margin
to increase packing density
to increase fan out

⇒ Addition of 0.3 to 3.5% silicon to iron
increases the electrical resistivity of iron
decreases the electrical resistivity of iron
does not change electrical resistivity of iron
silicon can't be added with iron

⇒ Nichol's chart is symmetric about - 180° axis.
TRUE
FALSE

⇒ Which one is digital modulation technique?
AM
PAM
PCM
None

⇒ An audio signal is to be transmitted digitally. Which is the system best suited for good fidelity?
8 bit PCM
13 bit PCM
32 bit PCM
PCM system with non-uniform quantizer

⇒ The current wave shown in figure is applied by a 0.1 F capacitor at t = 0. At t = 0⁺, the voltage across capacito
0
4 V
10 V
20 V

⇒ A FM signal with modulation index M_f is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
M_f
M_f/2
2M_f
UM_f

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ The value of parameter r_e used in r_e transistor model
increases with increase in temperature
decreases with increase in temperature
is not affected by increase in temperature
either (b) or (c)

⇒ A voltage wave having 5% fifth harmonic content is applied to a series RC circuit. The percentage fifth harmonic content in the current wave will be
0.05
more than 5%
less than 5%
equal or more than 5%

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ For an RC impedance function
all poles lie on jω axis
all poles are simple ,
all poles are simple and lie on negative real axis
none of the above

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒ A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be
10 V
12.5 V
14.1 V
15 V

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. When the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒ The logic operation that will selectively clear bits in register A in those positions where these are 1 's in the bits of register B is given by
A ← A + B
A ← AB
A ← A + B
A ← AB

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ In n type MOSFET, the substrate
is p type
is n type
is metallic
may be p or n type

⇒ Which of the following flip flops cannot be converted to D flip flop?
JK
SR
Master slave
None of the above

⇒ An n channel depletion type MOSFET has
lightly doped p substrate and highly doped n source and drain
highly doped p substrate and highly doped n source and drain
highly doped p substrate and lightly doped n source and drain
lightly doped n substrate and highly doped n source and drain

⇒ In a series RC circuit Z = (R² + ω²C²)^0.5.
TRUE
FALSE

⇒ The ratio of the diffusion coefficient in a semiconductor has the units
V^-1
em.V^-1
V.cm^-1
V.s

⇒ f_unity of an op-amp is about 1 kHz.
TRUE
FALSE