Question is ⇒ The point P in the following figure is stock at 1. The output f wil, Options are ⇒ (A) ABC, (B) A, (C) AB C, (D) A, (E) , Leave your comments or Download question paper.

Question is ⇒ The point P in the following figure is stock at 1. The output f wil, Options are ⇒ (A) ABC, (B) A, (C) AB C, (D) A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The point P in the following figure is stock at 1. The output f wil
A.	ABC [Wrong Answer]
B.	A [Wrong Answer]
C.	AB C [Wrong Answer]
D.	A [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As EM waves travel in free space they get
reflected
refracted
attenuated
absorbed

⇒ The main drawbacks of EEPROM are
low density
high cost
both low density and high cost
none of the above

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following cannot be the Fourier series expansion of a periodic signal?
x(t) = 2 cos t + 3 cos 3t
x(t) = 2 cos pt + 7 cos t
x(t) = cos t + 0.5
x(t) = 2 cos 1.5pt + sin 3.5 pt

⇒ V_L = 100 cos (10t + 30&d
116.57 sin (10t - 29°) V
116.57 sin (10t + 29°) V
117.00 sin (10t - 29°) V
117.00 sin (10t + 29°) V

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque
will be less than 100 N-m
will be more than 100 N-m
may be more or less than 100 N-m depending on motor parameters
very small

⇒

Assertion (A): Secondary instruments require calibration at frequent intervals.

Reason (R): Secondary instruments have many errors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A machine cycle has one clock cycle.
TRUE
FALSE

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively

⇒ The filter in figure, uses ideal op-amp. I
low pass filter
high pass filter
band pass filter
band stop filter

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ A Darlington pair is used for
low distortion
high frequency range
high power gain
high current gain

⇒ The ratio of impurity atoms to intrinsic semiconductor atoms in an extrinsic semiconductor is about.
0.0486111111111111
0.736111111111111
1 : 100000
1 : 10⁸

⇒ In a superheterodyne receiver, the IF is 455 kHz. If it is tuned to 1200 kHz, the image frequency will be
1655 kHz
2110 kHz
745 kHz
910 kHz

⇒ The contents of F register in 8085 are 01010001. This means
S = 0, Z = 1, AC = 1, P = 0 and CY=1
S = 1, Z = 1, AC = 1, P = 0 and CY=1
S = 1, Z = 0, AC = 1, P = 0 and CY=1
S = 1, Z = 0, AC = 0, P = 0 and CY=1

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A carrier wave carries information.
TRUE
FALSE

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased
dc output voltage and rms output voltage decrease in the same proportion
dc output voltage and rms output voltage decrease
dc output voltage and rms output voltage increase
dc output voltage and rms output voltage increase in the same proportion

⇒

Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect them

Reason (R): V_OH, V_OL, V_IH and V_IL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. V_IL and V_IH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ A FM signal with modulation index M_f is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
M_f
M_f/2
2M_f
UM_f

⇒ Volume control found on the front panel of television receivers
a ganged resistor
a variable resistor of logarithmic type
a variable resistor of linear type
a trimmer potentiometer

⇒ In the circuit of figure, PIV can be u
E_m
2 E_m
0.5 E_m
2 E_m

⇒ Direct and reflected sound waves may interfere with each other.
TRUE
FALSE

⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0

⇒ The system of linear equations 4x + 2y = 1 , 2x + y = 6 has
a unique solution
no solution
an infinite number of solutions
exactly two distinct solutions

⇒

Assertion (A): The Fourier series of the wave shown in the figure does not contain even harmao
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true