Question is ⇒ The phase of colour subcarrier burst in PAL is along the axis at, Options are ⇒ (A) +180°, (B) -180°, (C) ±180°, (D) ±45°, (E) , Leave your comments or Download question paper.

Question is ⇒ The phase of colour subcarrier burst in PAL is along the axis at, Options are ⇒ (A) +180°, (B) -180°, (C) ±180°, (D) ±45°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The phase of colour subcarrier burst in PAL is along the axis at
A.	+180° [Wrong Answer]
B.	-180° [Wrong Answer]
C.	±180° [Correct Answer]
D.	±45° [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the two port of figure, z_{1126/7 Ω
10/3 Ω
6 Ω
2 Ω}

⇒ What is the necessary a.c. input power from the transformer secondary used in a half wave rectifier to deliver 500 W of d.c. power to the load?
1232 W
848 W
616 W
308 W

⇒ The number of valence electrons in a donor atom is
2
3
4
5

⇒ If f₁ and f₂ and half-power frequency and f₀ be resonant frequency, the selectivity of R-L-C series circuit is given by
(f₂ - f₁)/2f₀
(f₂ - f₁)/f₀
(f₂ - f₀)/(f₁ - f₀)
(f₂ - f₁)/(f₁ - f₀)

⇒ In figure, the total power consume
10 W
12 W
16 W
20 W

⇒ Which of the following statements is false?
Push pull signals are equal and opposite in phase
Class AB operation cannot be used for a push pull audio power output phase
A push pull output transformer has a centre-tapped primary
All of the above

⇒ Neper is
larger than a decibel
smaller than decibel
equal to 1 decibel
none of the above

⇒ In which of the following is the width of junction barrier very small?
Tunnel diode
Photo diode
PIN diode
Schottky diode

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ In a zener diode
forward voltage rating is high
negative resistance characteristics exists
sharp breakdown occurs at low reverse voltage
none of the above

⇒ A 4 bit modulo 16 ripple counter uses JK flip-flops. If the propagation delay of each FF is 50 ns. The max. clock frequency that can be used is equal to
20 MHz
10 MHz
5 MHz
4 MHz

⇒ Consider the following statements

Tellegen's theorem is applicable to any lumped network.
Reciprocity theorem is applicable to linear bilateral network.
Thevenin theorem is applicable to two terminal linear active network.
Norton's theorem is applicable to linear active network.

Which of the above statements are correct?
1, 2 and 3
1, 2, 3 and 4
1, 2 and 4
3 and 4

⇒ If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :
DGη = 1
η = DG
D = ηG
D = G/η

⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ Capture effect occurs in
AM
FM
PCM
QAM

⇒ An m derived low pass filter has f_c = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
f = 1250 Hz
all frequencies above 1000 Hz
f = 1562.5 Hz
f = 1666.67 Hz

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W

⇒ Fleming's left hand rule is used to find
direction of force on a current carrying conductor
direction of flux in solenoid
direction of magnetic field due to a current carrying conductor
direction of induced emf

⇒ Push pull amplifier is
voltage amplifier
current amplifier
power amplifier
none of the above

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks

⇒ Which of the following statement is correct?
Decimal 9 is represented as 1011 in Excess-3 code
Decimal 9 is represented as 1001 is BCD code
Decimal 10 is represented as 1100 is Gray code
Decimal 10 is represented as 1001 in binary code

⇒ The different channels in a TDM receiver are separated by
integration
differentiation
AND gate
OR gate

⇒

Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The number of electrons in motion at the instant of positive peak of a symmetrical ac wave is the same as that at the instant of negative peak.
TRUE
FALSE

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ In a colour TV receiver the bandwidth of RF amplifier is
exactly equal to channel width
a little less than channel width
a little more than channel width
either (a) or (b)

⇒ Spontaneous magnetisation is characteristic of ferromagnetic materials.
TRUE
FALSE

⇒ For real and odd signals, the Fourier series coefficient a_n is
purely imaginary
purely real and even
purely imaginary and odd
purely real and odd

⇒

Assertion (A): Electron concentration n, hole concentration p and charge concentration n_i are related by n_i² = np.

Reason (R): p type semiconductor is obtained by adding trivalent impurity to intrinsic semiconductor.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true