Question is ⇒ The phase margin and damping ratio have no relation., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ The phase margin and damping ratio have no relation., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The phase margin and damping ratio have no relation.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ Which of the following is best excited from a waveguide?
Discone
Helical
Biconical
Horn

⇒ While forming Routh's array, the situation of a row of zeros indicates that the system
has symmetrically located roots
is not sensitive to variations in gain
is stable
is unstable

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ Armstrong FM transmitter uses
LC oscillator
crystal oscillator
RC oscillator
either (a) or (c)

⇒ In CE approximately, the active region is where the collector curves are
almost horizontal
almost vertical
inclined at 45°
inclined at 60°

⇒ During induction heating of metals which of the following is abnormally high?
Frequency
Voltage
Current
Power factor

⇒

Assertion (A): The scale a PMMC ammeter is linear.

Reason (R): The deflecting torque of PMMC is proportional to current in the coil.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The sinusoidally time varying vector fi
elliptically polarized
circularly polarized
linearly polarized
unpolarized

⇒ In a series L-C circuit fed by ac voltage, voltage drops across L and C are 40 V and 30 V respectively. The supply voltage is
70 V
10 V
50 V
1.333 V

⇒ JFET has __________ degree of isolation between input and output, and a __________ noise figure.
low, low
high, high
low, high
high, low

⇒ The ideal characteristics of a stabilizer is
constant output voltage with low internal resistance
constant output current with low internal resistance
constant output voltage with high internal resistance
constant internal resistance and constant output current

⇒ A twisted ring counter consisting of 4 FF will have
4 states
8 states
2⁴ states
None of the above

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
83.33 μ sec
1 μ sec
0.1 m sec
3.5 m sec

⇒ In a CRO the Y plates are oriented
horizontally
vertically
at an angle of 20° of horizontal
at an angle of 70° of horizontal

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒

Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ BPSK stands for
Binary Phase Shifting Key
Broad Phase Shifting Key
Bit Phase Shifting Key
Binary Pulse Shifting Key

⇒ Figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
0
1
AB
AB

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ With respect to transmission parameters, which one of the following is correct?
A and B are dimensionless
B and C are dimensionless
A and D are dimensionless
B and D are dimensionless

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above

⇒ A decade counter
counts for ten days
counts ten times faster than a binary counters
counts to 9 and reset on the next pulse
reverts on the pulse after the tenth

⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
0.004 Ω
0.005 Ω
0.05 Ω
0.1 Ω

⇒ The given figure shows a hybrid servosystem. The components 1, 2, 3, 4 are respecti
amplifier, demodulator, dc servomotor and load
demodulator, amplifier, dc servomotor and load
demodulator, dc servomotor, amplifier and load
amplifier, dc servomotor, demodulator and load

⇒

Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The Laplace transform of a unit step function is
1
1 / s
s
1 / s²

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ Figure shows a self bias circuit for FET amplifier, I_D = 4 mA. Then I_{S4 mA
2 mA
0.4 mA
0.2 mA}