Question is ⇒ The phase angle characteristic in the given figure is, Options are ⇒ (A) all pass function, (B) transport lag, (C) minimum phase function, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The phase angle characteristic in the given figure is, Options are ⇒ (A) all pass function, (B) transport lag, (C) minimum phase function, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The phase angle characteristic in the given figure is
A.	all pass function [Wrong Answer]
B.	transport lag [Correct Answer]
C.	minimum phase function [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a JFET
drain current is very nearly equal to source current
drain current is much less than source current
drain current may be equal to or less than source current
drain current may be even more than source current

⇒ The dynamic characteristics of capacitive transducer are similar to those of
LP filter
HP filter
notch filter
band stop filter

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ Regarding TASI which one of the following statements is wrong?
It snatches the channel in his speech and may allocate it to another speaker needing it.
The same speaker is reassigned a channel almost instantly when he speaks again even when the circuit is heavily loaded.
It increases the overall utilization of the transmission channel
Intercontinental callers sometimes confuse the effects of TASI with the effects of satellite delay.

⇒ The function of duplexer in a RADAR is
to permit the use of same antenna for transmission and reception
to provide gain to the transmitted power
to amplify the received signal
both (b) and (c)

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒

Assertion (A): Impatt diode is an avalanche diode.

Reason (R): Avalanche breakdown phenomenon occurs when a p-n junction is reverse biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a Hurwitz polynomial
all coefficients are non-negative
both the odd and even parts have roots on jω axis
the continued fraction expansion is the ratio of odd to even parts of a Hurwitz polynomial yields all positive quotient terms
all of the above

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒

Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions.

Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these

⇒ In metals the valence electron wave functions are strongly perturbed by the presence of neighbouring atoms.
TRUE
FALSE

⇒ The access time of a word in 4 MB main memory is 100 ms. The access time of a word in a 32 kb data cache memory is 10 ns. The average data cache bit ratio is 0.95. The efficiency of memory access time is
9.5 ns
14.5 ns
20 ns
95 ns

⇒ In P-N junction, the region containing the uncompensated acceptor and donor ions is called
transition zone
depletion region
neutral region
active region

⇒ The output of the 74 series of TTL gates is taken from a BST in
totem pole and common collector configuration
either totem pole or open collector configuration
common base configuration
common collector configuration

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ The mean life time of the minority carriers is in the range of a few
seconds
milli seconds
micro seconds
nano seconds

⇒ The commutation method in an inverter, is
line commutation
forced commutation
either (a) or (b)
none of the above

⇒

Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.

Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A dual converter may be circulating current type or non circulating current type.

Reason (R): In circulating current dual converter only one converter can be operated at one time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): ECL gate has very high speed of operation.

Reason (R): Transistors in ECL do not go into saturation region.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A 4 bit synchronous counter has flip flops having propagation delay of 50 ns each and AND gates having propagation delay of 20 ns each. The maximum frequency of clock pulses can be
20 MHz
50 MHz
14.3 MHz
5 MHz

⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE

⇒ In figure we need an ac ground. The proper value of
1000 μF
100 μF
10 μF
1 μF

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
636 pF
180 pF
65 pF
30 pF

⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?
line open circuited at far end
line terminated in Z₀
line short circuited at far end
line terminated in inductance

⇒ In figure, the time constant for the capacitor chargin
6 μs
10 μs
15 μs
25 μs

⇒ A capacitor does not allow sudden changes
in currents
in voltage
in both current and voltage
neither of two

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒ Accurate amplitude measurements can be made more easily than accurate phase shift measurements.
TRUE
FALSE