Question is ⇒ The PAM Signal can be detected by, Options are ⇒ (A) Band pass filter, (B) Band stop filter, (C) High pass filter, (D) Low pass filter, (E) , Leave your comments or Download question paper.

Question is ⇒ The PAM Signal can be detected by, Options are ⇒ (A) Band pass filter, (B) Band stop filter, (C) High pass filter, (D) Low pass filter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The PAM Signal can be detected by
A.	Band pass filter [Wrong Answer]
B.	Band stop filter [Wrong Answer]
C.	High pass filter [Wrong Answer]
D.	Low pass filter [Correct Answer]
View Answer 3 -11 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The capacitor filter provides poor voltage regulation because
the increase in ripple with load current causes a decrease in average voltage
the increase in ripple with load current causes a increase in average voltage
filter promotes ripple at peak voltage
none of the above

⇒ A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
a straight line parallel to Y axis in 4th quadrant
a straight line parallel to X axis in 4th quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ A P-channel MOSFET operating in the enhancement mode is characterized by V_t = - 4 V and I_DQ = - 10 mA, when V_GSQ = - 5.5 V, what will be V_GSQ if I_DQ = -15 mA and I_{D, on} = - 16 mA
- 2 V
3 V
0.13 V
1.3 V

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ If the current in a capacitor leads the voltage by 80°, the loss angle of capacitor is
80°
10°
100°
170°

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency

⇒ Between which regions does BJT act like switch?
Cut off and saturation
Cut off and forward active
Forward active and cut off
Saturation and active

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ Which of the following is not valid integer variable in FORTRAN 77?
MBR
LOTS
JAMMU
BRG

⇒ In a solar cell, the photovoltaic voltages is the voltage at which the resultant current is
positive
zero
negative
rated current

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in backward direction. A moving coil ammeter is also connected in the circuit. The reading of ammeter will be
0.416666666666667
0.208333333333333
3.185 A
14.14 A

⇒ Computers 'Basic input output system' is generally stored in RAM chips.
TRUE
FALSE

⇒ Which of following antenna produces elliptical polarisation?
Helical
Parabolic
Dipole
None

⇒ Which type of gate is in the given fig
NOR
OR
NAND
EX-OR

⇒ A 24 mm long conductor has a resistance of 128 Ω. The change in resistance is 13.3 Ω and change in length is 1.6 mm under tension. The gauge factor is
1.2
1.6
2.1
2.6

⇒ A Q meter uses the principle of
variation of self inductance
variation of mutual inductance
series resonance
none of the above

⇒ In push button type telephone set, pressing a button generates
one frequency
two high frequencies
two low frequencies
one low frequency and one high frequency

⇒ The natural frequency S_n of the given circui
-1
1
42737
-2

⇒ Some ADCs are

Parallel
Updown
Single slope
Dual slope
Successive approximation
Stair step

Out of above which ones do not use DAC?
1 only
1, 3, 4
1, 2, 3
1, 5, 6

⇒

Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index m_t
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure the total inductance of the circui
L₁ + L₂
L₁ + L₂ - M
L₁ + L₂ - 2M
L₁ + L₂ + M

⇒ Heating effect of current is used in
ammeters
voltmeters
both ammeters and voltmeters
wattmeters

⇒ The depth of modulation is doubled in FM system then, the power transmitted
increase by factor of 2
increase by factor of 3
increase by factor of 2
none of the above

⇒ In figure, capacitor is used to develop pulses of short duration and large duty cycle across R₂ when switch is closed. Which of the following combinations is best sui
R₁ and R₂ large but C small
R₁ and R₂ small but C large
R₁ and C large and R₂ small
R₂ and C large but R₁ small

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ In a radar, the return echo arrives after the allocated pulse interval. Then
the receiver may be over loaded
the target will appear closer than its actual position
the return echo may interfere with transmitter operation
none of the above

⇒ Typical values of current gains for CE, CB and CC amplifiers are
120, 120 and 1 respectively
120, 1 and 120 respectively
1, 120 and 120 respectively
1, 1 and 120 respectively

⇒ Which of the following statement regarding the advantages of the phase discriminator over the slope detector is false?
Better linearity
Fewer tuned circuits
Much easier alignment
Greater limiting

⇒ A magnet does not attract
nickel
iron
copper
iron and copper