Question is ⇒ The output wave of a cycloconverter consists of a number of segments derived from the input wave., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ The output wave of a cycloconverter consists of a number of segments derived from the input wave., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The output wave of a cycloconverter consists of a number of segments derived from the input wave.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is not a valid real variable in FORTRAN 77?
ANUT
MONEY
A MONEY
BS

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒ In root locus analysis the breakaway and break in points
lie on the real axis
either lie on the real axis or occur in complex conjugate pairs
always occur in complex conjugate pairs
none of the above

⇒ The traffic-handling capacity of an Earth station on the uplink depends on
its EIRP
satellite antenna gain
noise associated with the satellite
all of the above

⇒ Which has volatile memory?
Magnetic tape
RAM
Diskette
Hard disk

⇒ If the number of ways an event may result ins analysed into m successes and n failures, each equally likely to occur, the probability of success in a single trial is m( m + n)
TRUE
FALSE

⇒

Assertion (A): A slight change in pole-zero configuration can cause only minor changes in root locus configuration.

Reason (R): Asymptotes show the behaviour of root loci for |s| >> 1

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A static excitation system uses
transformer and thyristors
transformer and ac exciter
dc exciter and ac exciter
transformer and dc exciter

⇒ Which of the following input is not possible in case of a SR flip-flop?
S = 0, R = 0
S = 0, R = 1
S = 1, R = 0
S = 1, R = 1

⇒ Which of the following statements is not correct for thermistors?
They have negative temperature coefficient of resistance
The sensing element is made of sintered ceramics, which are oxides of metals in the form of beads
The variation of resistance with temperature is linear
The resistance value at ambient temperature may range from 100 Ω to 100 kΩ

⇒ In pulse transmitter the ratio of time on to time off is called
efficiency
duty cycle
base
bandwidth

⇒ Cassergain feed is used with a parabolic reflector to
increase the gain of the system
increase the beamwidth of the system
reduce the size of the main reflector
allow the feed to be placed at a convenient point

⇒ An open wire transmission line having a characteristic impedance of 600 ohms is terminated by a resistive load of 900 Ω. The standing wave ratio will be
1.5
2.5
3.5
4.5

⇒ What can be the maximum dimension of an array in C language program?
3
4
5
It is compiler dependent

⇒ The atomic number of silicon is 14. It can be therefore concluded that
a silicon atom contains 14 protons
a silicon atom contains 14 neutrons
a silicon atom contains 14 electrons
all of the above

⇒ The application of gate signal decreases the break over voltage of on SCR.
TRUE
FALSE

⇒ Transconductance characteristics of JFET depict the relation between
I_D and V_GS for different value of V_DS
I_D and V_DS for different value of V_GS
V_GS and V_DS for different values of I_D
V_DS and I_D for different values of V_GS

⇒ In an ac network the sum of currents entering a node is 10 ∠45°. The sum of currents leaving the node is
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ Twelve 1 Ω resistance are used as edges to form a cube. The resistance between two diagonally opposite corners of the cube is
5/6 Ω
1 Ω
6/5 Ω
3/2 Ω

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ Low frequency boost can be easily compensated by
attenuating the frequencies from 0 to 1.25 MHz
using an appropriate de-emphasis circuit in the receiver
using an appropriate pre-emphasis circuit in the transmitter
none

⇒ Consider the following expressions which indicate the step or impulse response of an initially relaxed system

[5 - 4 e^-2t] u(t)
[e^-2t + 5] u(t)
d(t) + 8 e^-2t u(t)
d(t) + 4 e^-2t u(t)

Those which correspond to the step and impulse response of the same system include
1 and 3
1 and 4
2 and 4
2 and 3

⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as
A ⊕ B ⊕ D
A ⊕ B ⊕ E
A ⊕ E
A ⊕ E

⇒ The frequency range for satellite communication is
3 to 30 kHz
300 to 3000 kHz
3000 to 30000 MHz
30000 to 300000 MHz

⇒

Match the following:

	List I		List II
A.	Direct addressing	1.	MOV A, M
B.	Register addressing	2.	MOV C, A
C.	Register indirect addressing	3.	LDA 7
D.	Immediate addressing	4.	STA FFC

A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3
A-2, B-3, C-4, D-1
A-3, B-2, C-1, D-4

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒ Which of the following term applies to troposcatter propagation?
SIDs
Faraday rotation
Atmospheric storms
Fading

⇒ The dominant mode in a rectangular wave-guide is
TE₀₁
TM₀₁
TE₁₀
TM₁₁

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage