Question is ⇒ The output V<sub>0</sub> in figur, Options are ⇒ (A) -100 V, (B) -100 mV, (C) 10 V, (D) 10 mV, (E) , Leave your comments or Download question paper.

Question is ⇒ The output V<sub>0</sub> in figur, Options are ⇒ (A) -100 V, (B) -100 mV, (C) 10 V, (D) 10 mV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The output V₀ in figur
A.	-100 V [Wrong Answer]
B.	-100 mV [Correct Answer]
C.	10 V [Wrong Answer]
D.	10 mV [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When large amount of power is required, a push pull amplifier is designed for operation as
class A
class B
class C
class AB

⇒ A mod-2 counter followed by a mod 5 is same as
mod-7 counter
A decade counter
mod-3 counter
none

⇒ An RC driving point impedance function has zeros at s = - 2 and s = - 5. The admissible poles are
s = 0 and s = -6
s = -1 and s = -3
s = 0 and s = -1
s = -3 and s = -4

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ In fabricating silicon BJT in ICs by the epitaxial process, the number of diffusions used is usually
2
3
4
6

⇒ A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is
100 MHz
50 MHz
12.5 MHz
6.25 MHz

⇒ In the expression 3 * * 2 ** 4 ** 2 in FORTRAN 77 which exponentiation is performed first
4 * * 2
2 * * 4
3 * * 2
all exponentiation are performed together

⇒ A 200 turn coil has a self inductance of 10 mH. If the number of turns is doubled, all other quantities remaining the same, the self inductance will be
2.5 mH
5 mH
20 mH
40 mH

⇒ FM has
two sidebands only
four sidebands only
eight sidebands only
infinite sidebands

⇒

Assertion (A): Moving iron instrument can be used on ac or dc.

Reason (R): In a moving iron instrument deflecting torque is proportional to square of current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which type of gate is in the given fig
NOR
OR
NAND
EX-OR

⇒

Assertion (A): Chopper always requires forced commutation

Reason (R): Morgan chopper uses a saturable reactor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a CE amplifier circuit, the output voltage
is very small
is always constant
depends on β
none of the above

⇒ In the basic series inverter circuit, the source current has
low harmonic content
high harmonic content
low or high harmonic content depending on firing angle
zero harmonic content

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_B
24 μA
23 μA
20 μA
10 μA

⇒ Which of the following polynomials is not Hurwitz?
P₁ = s⁸ + 2s⁶ + 4s⁴
P₂ = s⁶ - 3s⁴ + 2s² + 1
P₃ = s⁴ + 3s³ + 3s² + 2s + 1
P₄ = s⁷ + 2s⁶ 2s⁴ + 4s³ + 8s² + 8s + 4

⇒ A 12 bit ADC is used to convert analog voltage of 0 to 10 V into digital. The resolution is
2.44 mV
24.4 mV
1.2 V
none of the above

⇒ Consider the following network func
zero at origin
zero at infinity
pole at origin
pole at infinity

⇒ A D.C. amplifier amplify
D.C. only
A.C. only
both A.C. and D.C.
none of the above.

⇒ The storage capacity of DSDD disk and DSHD disk are
1.2 MB each
360 KB each
1.2 MB and 360 KB respectively
360 KB and 1.2 MB respectively

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
RST 5.5
RST 7.5
TRAP
INTR

⇒ The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
R/LC
C/LR
LC/R
L/CR

⇒ To eliminate ghosts in the picture
use a longer transmission line
connect a booster
change the antenna orientation of location
twist the transmission line

⇒ Transconductance indicates the
control of output voltage by input voltage
control of output current by input voltage
control of input voltage by output current
control of input current by input voltage

⇒ To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use
surge resistor
surge inductor
surge capacitor
both (a) and (b)

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒ Consider the following statements about a good power supply:

The a.c. ripple should be high
S_v, (Voltage stability factor) should be low
S_T, (Temperature stability factor) should be low

Which of the above statements are correct?
1, 2 and 3
2 only
3 only
2 and 3 only

⇒ The number of tightly bound electrons in silicon atom are
14
10
6
4

⇒ For the circuit shown in figure low cut-off frequenc
1.59 Hz
159 Hz
1.59 kHz
1.59 MHz