Question is ⇒ The output of basic DTL configuration is, Options are ⇒ (A) low when one of the input is high, (B) low when all inputs are high, (C) high when all inputs are high, (D) high when all inputs are low, (E) , Leave your comments or Download question paper.

Question is ⇒ The output of basic DTL configuration is, Options are ⇒ (A) low when one of the input is high, (B) low when all inputs are high, (C) high when all inputs are high, (D) high when all inputs are low, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The output of basic DTL configuration is
A.	low when one of the input is high [Wrong Answer]
B.	low when all inputs are high [Correct Answer]
C.	high when all inputs are high [Wrong Answer]
D.	high when all inputs are low [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The self bias provides
stable Q point
large voltage gain
high input impedance
high base current

⇒ Consider the following statements about advantages of phase discriminator over slope detector

Fewer tuned circuits
Greater limiting
Better linearity
Easy alignment

Which of the above are true?
1, 2, 3, 4
2, 3, 4
1, 2, 3
1, 3, 4

⇒

Assertion (A): When a function f(t) is represented as exponential Fourier series, the set of complex coefficients F_n is called frequency spectrum of f(t)

Reason (R): Frequency spectrum is also called line spectrum.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ A coaxial RF cable has a characteristic impedance of 50 Ω and C equal to 40 pF/m. The inductance is
1 μ H/m
10 μ H/m
0.1 μ H/m
0.01 μ H/m

⇒ Piezoelectric effect can be used to measure
force
strain
acceleration
all of the above

⇒ In Gunn diode electrons are transferred from
Ridge guide is essentially a form of capacitively loaded guide
low to high mobility energy bands
valley to domain formation
domain to valley formation

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ The number of protons in a silicon atom are
4
8
12
14

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ In a Hurwitz polynomial
all coefficients are non-negative
both the odd and even parts have roots on jω axis
the continued fraction expansion is the ratio of odd to even parts of a Hurwitz polynomial yields all positive quotient terms
all of the above

⇒

Assertion (A): Integral control action is sometimes called reset control.

Reason (R): Reset rate is expressed as number of repeats per unit time.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒ If the peak transmitted power in a radar is increased by a factor 81, the maximum range is increased by a factor of
3
9
27
81

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If L [f(t)] = F(s), Lf(t - T)
e^sTF(s)
e^-sTF(s)
F(s) - e^-sT
F(s) + e^-sT

⇒ Consider the following statements for a driving point function F(jω):

Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.

Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒ A voltage tripler circuit and voltage quadrupler circuit use identical components. Then
voltage regulation in both circuits will be same
voltage regulation in both may or may not be same
voltage regulation in quadrupler circuit will be better than in tripler circuit
voltage regulation in quadrupler circuit will be poorer than in tripler circuit

⇒ When a UJT is used as a relaxation oscillator the current should be
less than I_p
more than I_v
more than I_p but less than I_v
negative

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒ The orientation polarization is

directly proportional to temperature
inversely proportional to temperature
inversely proportional to square of permanent dipole moment
directly proportional to square of permanent dipole moment.

Which of the above are correct?
1 and 3 only
2 and 3 only
1 and 4 only
2 and 4 only

⇒ (2)₃ + (3)₄ = (?)₅
4
11
none of these
not possible

⇒ Spot the odd one out
aluminium
silver
porcelain
copper

⇒ In figure, D₂ turns on
v_i is more positive than V₁
v_i is less positive than V₁
v_i is more negative than V₂
v_i is less negative than V₂

⇒ Consider the following statements.

Etching
Exposure to UV radiation
Stripping
Developing

After a wafer has been coated with photo resist the correct sequence of these steps in photolithography is
2, 4, 3, 1
2, 4, 1, 3
4, 2, 1, 3
3, 2, 3, 1

⇒ The pure capacitor connected across an A.C. voltage consumed 20 W. This is due to
the capacitive reactance in ohms
the current flowing in the capacitor
the fused capacitor was a big one
none of the above

⇒ The region between a pin of parallel perfectly conducting planes of infinite extent is y and z directions is partially filled with a dielectric as shown be
-2
2
0
1

⇒ When the phase velocity of an EM wave depends on frequency in any medium, the phenomenon is called
scattering
polarization
absorption
dispersion

⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.