Question is ⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as, Options are ⇒ (A) saturation region, active region and breakdown region, (B) inactive region, active region and breakdown region, (C) inactive region, saturation region and active region, (D) inactive region, saturation region and breakdown region, (E) , Leave your comments or Download question paper.

Question is ⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as, Options are ⇒ (A) saturation region, active region and breakdown region, (B) inactive region, active region and breakdown region, (C) inactive region, saturation region and active region, (D) inactive region, saturation region and breakdown region, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The output characteristics of a bipolar transistor has three distinct regions. They are known as
A.	saturation region, active region and breakdown region [Correct Answer]
B.	inactive region, active region and breakdown region [Wrong Answer]
C.	inactive region, saturation region and active region [Wrong Answer]
D.	inactive region, saturation region and breakdown region [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A class C chopper can operate in first and second quadrants

Reason (R): A class B chopper operates only in second quadrant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA

⇒ __________ switch, a T flip-flop is used as __________ switch, a T flip-flop is used as switch
toggled, delay
delay, toggle
set reset
reset, set

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40.12
4.878
2.2

⇒ If a sheet of a mica is inserted between the plates of an air capacitor, the capacitance
will increase
will return the same
will decrease
may increase or decrease

⇒ 110.11₂ x 110₂ = __________ ₁₀
40.5
30.5
20.5
10.5

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ The relationship of hysteresis loss to maximum flux density was first determined by
C. Steinmetz
G.R. Kirchoff
Mr. Laplace
Mr. Ampere

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ Which of the following devices uses a slow wave structure?
Klystron two cavity amplifier
Klystron multicavity amplifier
Reflex klystron oscillator
TWT

⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
60 and 15
15 and 60
6 and 1.5
1.5 and 6

⇒ Which of the following devices should be used for accurate measurement of a low dc voltage?
Small range moving coil voltmeter
Dc potentiometer
Small range thermocouple voltmeter
Hot wire instrument

⇒ A vacant electronic state moves in the same direction as would a positive charge carrier.
TRUE
FALSE

⇒ For a periodic signal with finite number of discontinuities in each period, at isolated points of discontinuity the series converges to __________ .
difference value of signal on either side of discontinuity
highest value of signal on either side of discontinuity
average value of signal on either side of discontinuity
sum of value of signal on either side of discontinuity

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.
TRUE
FALSE

⇒ In terms of ABCD parameters, the image parameter Z₁₁ is equal to
AC/BD
BD/AC
AB/CD
AD/BC

⇒ Which of the following noise does not occur in transistors?
Partition noise
Shot noise
Flicker noise
Resistance noise

⇒ A satellite that simply reflect back the signals from one region of the earth to the other region is known as
orbiting satellite
geostationary satellite
active satellite
passive satellite

⇒ The power in the signal s(t) = 8 cos (20 p - p/2) + 4 sin (15 pt) is
40
41
42
82

⇒ If the mantissa has a sign bit of 0 and the exponent is changed from a negative number to a more positive number the result is
a positive number and closer to zero
a positive number and away from zero
a negative number
a negative number and closer to zero

⇒ An 8 bit DAC has a full scale output of 2 mA and full scale error of ± 0.5%. If input is 10000000 the range of outputs is
994 to 1014 μA
990 to 1020 μA
800 to 1200 μA
none of the above

⇒ A planar graph has 6 nodes and 7 branches. The number of meshes in the dual graph is
2
3
4
6

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ When thyristors are connected in series and parallel, it may be necessary to have :
current derating
voltage derating
both current and voltage derating
none of the above

⇒ In figure V is ideal voltmeter having infinite resistance. It will read __________ v
40
60
0
100

⇒ An astable multivibrator circuit using IC 555 timer is shown below. Assume that the circuit is oscillating stea
3 V to 5 V
3 V to 6 V
3.6 V to 6 V
3.6 V to 5 V