Question is ⇒ The number of roots of s3 + 2s2 + 7s + 3 = 0 in the left half of the s-plane is :, Options are ⇒ (A) zero, (B) one, (C) two, (D) three, (E) , Leave your comments or Download question paper.

Question is ⇒ The number of roots of s3 + 2s2 + 7s + 3 = 0 in the left half of the s-plane is :, Options are ⇒ (A) zero, (B) one, (C) two, (D) three, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The number of roots of s³ + 2s² + 7s + 3 = 0 in the left half of the s-plane is :
A.	zero [Wrong Answer]
B.	one [Wrong Answer]
C.	two [Wrong Answer]
D.	three [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.

Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ Each cell of a static RAM has
4 MOS transistors
4 MOS transistors and 2 capacitors
2 MOS transistors and two capacitors
1 MOS transistor and 1 capacitor

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
0.6
0.25
4
0.36

⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability

⇒ Frequency shift keying is used mostly in
telephony
telegraphy
radio transmission
none of the above

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will
decrease to finite non-zero value
remain the same
increase
decrease to zero

⇒ For a two- port reciprocal network, the output open circuit voltage divided by the input current is equal to
B
Z₁₂
1/y₁₂
h₁₂

⇒ Which camera tube has highest dark current?
Plumbicon
Vidicon
Saticon
GCD imager

⇒ Above a certain temperature, the specific heat of a metal becomes constant. This temperature is called
Debye temperature
Curie temperature
Neel temperature
Transition temperature

⇒ In a power system, reactive power is necessary for
power transmission
stabilising the voltage level
counteracting the effect of reactance in the transmission system
none of the above

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒

Assertion (A): Power drain of CMOS increases with operating frequency

Reason (R): All unused CMOS inputs should be tied either to a fixed voltage level (0 or V_DD) or to another input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For a quadratic factor in transfer function the phase angle is not a function of damping factor.
TRUE
FALSE

⇒ When three 100 K, ± 10% fixed resistors of 1/4 W Power rating are connected in parallel, the resulting 33 K resistor will have a tolerance specification and power rating of
± 10% and 3/4 W respectively
± 10% and 1/12 W respectively
± 3.3.% and 3/4 W respectively
± 30% and 3/4 W respectively

⇒ At FM demodulator output noise power density
increases with frequency
decreases with frequency
remains unaltered
none of the above

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ The beam of a radar should be
very narrow
very wide
neither too narrow nor very wide
either (b) or (c)

⇒ A basic group B
consists of five super groups
has a frequency range of 60 to 108 kHz
consists of erect channels only
is formed at group translating equipment

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ A JFET
is current controlled device
has low input resistance
has high gate current
is a voltage controlled device

⇒ The noise figure of multicavity klystron amplifier is very low
TRUE
FALSE

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ In a reflex klystron oscillator, repeller electrode is at
low positive potential
high positive potential
negative potential
zero potential

⇒ The resistivity of ferrites is
very much lower than that of the ferromagnetic metals
slightly lower than that of the ferromagnetic materials
slightly higher than that of the ferromagnetic metals
very much higher than that of the ferromagnetic metals