Question is ⇒ The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about, Options are ⇒ (A) 10, (B) 100, (C) 500, (D) 1500, (E) , Leave your comments or Download question paper.

Question is ⇒ The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about, Options are ⇒ (A) 10, (B) 100, (C) 500, (D) 1500, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about
A.	10 [Wrong Answer]
B.	100 [Wrong Answer]
C.	500 [Wrong Answer]
D.	1500 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ Which of the following statement about the advantage of phase discriminator over the slope detector is false?
Fewer tuned circuits
Better linearity
Greater limiting
Much easier alignment

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1

⇒ In the circuit shown in figure the current I of sinusoidal sourc
25 A
0.166666666666667
20 A
Not determinable from given data

⇒ The hexadecimal number 'A0' has the decimal value
80
256
100
160

⇒ Consider the following statements as regards BPSK and QPSK:

In BPSK we deal individually with each bit of duration T_b
In QPSK we lump two bits to form a symbol
In both BPSK and QPSK signal changes occur at bit rate
In QPSK the symbol can have any one of four possible values

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
1, 2, 4
2, 3, 4

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ If D is mouth diameter of a paraboloid reflector, its directivity is proportional to
D
D²
D
D³

⇒ In CE approximately, the active region is where the collector curves are
almost horizontal
almost vertical
inclined at 45°
inclined at 60°

⇒ Most of the digital computers do not have floating-point hardware because
floating point hardware is costly
it is slower than software
it is not possible to perform floating point addition by hardware
of not specific reason

⇒ If A = 3 + j1 and B = 4 + j3, A + B =
7 ∠45°
10 ∠45°
8.062 ∠29.7°
8.062 ∠73°

⇒ An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be
50 kHz
20 kHz
100 kHz
infinite

⇒ An angle modulated signal is given by s(t) = cos 2p (2 x 10⁶t + 30 sin 150t + 40 cos 150t). The maximum frequency and phase deviations of s(t) are
10.5 kHz, 140p rad
6 kHz and 80p rad
10.5 kHz, 100p rad
7.5 kHz, 100p rad

⇒ Which of the following antennas uses a number of varying length parallel elements?
Helical antenna
Pyramidal Horn
Comer reflection antenna
Yagi-Uda antenna

⇒ The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W, respectively
35 A, 350 W, respectively
5 A, 250 W, respectively
11 A, 1210 W, respectively

⇒ In 8085
the upper 8 address bits appear on address bus and lower 8 bits on address data bus
the lower 8 address bits appear on address bus and the upper 8 address bits appear on address data bus
either upper or lower 8 address bits may appear at address bus
either upper or lower 8 address bits may appear at address data bus

⇒ Holes and electrons move in opposite directions.
TRUE
FALSE

⇒

Match the following:

	List I (Set operation)		List II (Set operator)
A.	Set equality	1.	-
B.	Set inclusion	2.	=
C.	Set intersection	3.	< =
D.	Set difference	4.	∗

A-2, B-3, C-4, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1

⇒ Lines of magnetic field attract each other.
TRUE
FALSE

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.
4 cm
1 cm
2 cm
8 cm

⇒ The expression Y (A, B, C) = ∑m (1, 3, 5, 6) is to realized using a multiplexer. Then
use 8 : 1 multiplexer and ground input lines 1, 3, 5, 6
use 8 : 1 multiplexer and ground input lines 0, 2, 4, 7
use 8 : 1 multiplexer and ground input lines 0, 1, 2, 3
use 8 : 1 multiplexer and ground input lines 4, 5, 6, 7

⇒ NAND and NOR gates are universal gates.
TRUE
FALSE

⇒ The feedback resistance r_d in small signal model of MOSFET is of the order of
1000 MΩ
1 MΩ
1 KΩ
100 Ω

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ 8255 A is a
programmable peripheral interface
I/O device
memory chip
none of the above

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency