Question is ⇒ The number of lobes on each side of a 31 resonant antenna will be, Options are ⇒ (A) 2, (B) 3, (C) 4, (D) 6, (E) , Leave your comments or Download question paper.

Question is ⇒ The number of lobes on each side of a 31 resonant antenna will be, Options are ⇒ (A) 2, (B) 3, (C) 4, (D) 6, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The number of lobes on each side of a 31 resonant antenna will be
A.	2 [Wrong Answer]
B.	3 [Wrong Answer]
C.	4 [Wrong Answer]
D.	6 [Correct Answer]
View Answer 3 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an home T.V. receiver, the leed in from the antenna is
coaxial cable of 75 Ω
ordinary twisted wire
bar copper wire
twin wire

⇒ Piezoelectric effect can be used to measure
force
strain
acceleration
all of the above

⇒

Assertion (A): Standard deviation is the abscissa of a point of inflection on the probability curve.

Reason (R): The equation for probability curv
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ The ripple factor of power supply is a measure of
its filter efficiency
diode rating
its voltage regulation
purity of power output

⇒ The Shannon-Hartley law
refers to noise
defines bandwidth
describes signalling rate
refers to distortion

⇒ In a RS flip-flop no change occurs during
prohibited mode
set mode
reset mode
disable mode

⇒ Hysteresis loss in a transformer working at 220 V and at a frequency of 50 Hz is 100 W. When the transformer is operated at 220 V and at a frequency of 100 Hz, what is the hysteresis loss?
50 W
100 W
200 W
400 W

⇒ In an oscillator the total phase shift around the loop must be
180°
90°
270°
0°

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is
0.1 m V
0.4 m V
1 m V
4 m V

⇒ A series resonant circuit has R = 2 Ω, L = 0.1 H and C =10 μF. At resonance applied voltage = 10 ∠0 V. Voltage across inductance is likely to be
10 ∠0 V
10 ∠45° V
100 ∠90° V
100 ∠-90° V

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
-90°
0°
90°
-180°

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ An induction wattmeter can be used for ac only.
TRUE
FALSE

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ The current through a resistance R is shown in figure. The computed value of power
400 ± 0.42 W
400 ± 4.6 W
400 ± 8.85 W
400 ± 10.65 W

⇒ The Thevenin equivalent circuit to the left of AB has R_{eq2 Ω
4 Ω
1 Ω
3 Ω}

⇒ A short-circuit is that which is
used short pieces of wire
goes only a short distance
is used for dimming light
offer very low resistance path for current to flow

⇒ In case of a transistor amplifier the emitter resistance R_e is removed
the gain of the amplifier will reduce
heat sink will not be required
Q-point will become unstable
base to emitter function will be less forward biased

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ Tuned voltage amplifiers are not used
radio receivers
public address system
T.V. Receivers
band of freq. selected and amplified

⇒ The effect of the inductance of a coil on a constant direct current is that
it does not effect the constant direct current
it decreases the current
it strengthens the current
it causes a higher voltage drop

⇒ An RC circuit initially at rest has a step signal. The response V(t) across C is V(t) = 1 - e^-at, If now there is an initial voltage on C of 2 volts for the same step signal, V(t) is now
1 + e ^-at
1 + 2e ^-at
2 - e ^-at
3 - e ^-at