Question is ⇒ The noise margin of a TTL gate is about, Options are ⇒ (A) 0.2 V, (B) 0.4 V, (C) 0.6 V, (D) 0.8 V, (E) , Leave your comments or Download question paper.

Question is ⇒ The noise margin of a TTL gate is about, Options are ⇒ (A) 0.2 V, (B) 0.4 V, (C) 0.6 V, (D) 0.8 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The noise margin of a TTL gate is about
A.	0.2 V [Wrong Answer]
B.	0.4 V [Wrong Answer]
C.	0.6 V [Correct Answer]
D.	0.8 V [Wrong Answer]
View Answer 4 -21 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A wire is carrying current I. The field intensity H at a distance r from the wire
is directed towards wire
is directed away from wire
is tangential every where to a circle of radius r
none of the above

⇒ The PAM Signal can be detected by
Band pass filter
Band stop filter
High pass filter
Low pass filter

⇒ A transistor amplifier is operating in class A mode. If a transformer is connected for impedance matching, the efficiency will
increase
decrease
not be affected
increase or decrease

⇒ A voltmeter using thermocouples measures
rms value
peak value
average value
peak to peak value

⇒ For operation of enhancement only N-channel MOSFET, value of gate voltage has to be
zero
low positive
high negative
high positive

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE₁₀ mode is
1.5 x 10⁸ m/s
5.5 x 10⁸ m/s
3.46 x 10⁸ m/s
0.18 x 10⁷ m/s

⇒ In the given figure shows a logic circuit. The minimum Boolean expression for this circui
A + B
A + B + C
AB + C
AB + AC + BC

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A system is stable if ROC
include the unit circle
exclude the unit circle
lies on Circle
entire plane

⇒ Image frequency rejection mainly depends upon
detector
mixer
IF
RF

⇒ If an admittance Y(s) has a term Ks, the realization would give
an inductance of value K
a resistance of value K
a capacitance of value K
either (a) or(c)

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒

Match the following:

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used

A-4, B-1, C-3, D-2
A-3, B-4, C-1, D-2
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1

⇒ The depth of modulation is doubled in FM system then, the power transmitted
increase by factor of 2
increase by factor of 3
increase by factor of 2
none of the above

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

⇒ For an P-N-P transistor in normal operation its junction are biased as
emitter base : reverse, collector base : forward
emitter base : forward, collector base : reverse
emitter base : forward, collector base : forward
emitter base : reverse, collector base : reverse

⇒ In the circuit, V_s = 10 cos ωt, power drawn by the 4Ω resistor is 8 watt. The power facto
1
0.5
0.85
0

⇒ In figure I_D = 4 mA. Then V_{S20 V
4.4 V
0.4 V
0.44 V}

⇒ Class A and Class B power amplifiers predominate at
audio frequencies
radio frequencies
all frequencies
audio and radio frequency

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ In a single phase full wave converter (M - 2 connection) feeding a highly inductive load, the firing angle for each thyristor is a in the respective half cycle. The period of conduction of each thyristor is
p - a
p
p + a
p - 2a

⇒ If the ratio p(s)/q(s) represents a transfer function then
the degree of p(s) may be as small as zero, independent of degree of q(s)
the degree of p(s) and q(s) must be equal
the degrees of p(s) and q(s) must not be equal
the degrees p(s) and q(s) must differ by at least two

⇒ The energy of constant-amplitude complex valued exponential sequence is __________ (where A is the constant amplitude)
0
1
∞
A²

⇒ A class A chopper has an input voltage of 200 V. T_on = 1.5 ms and T_off = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are
0.5, 100 V and 1
0.25, 50 V and 3
0.25, 50 V and 1
0.5, 100 V and 3

⇒

Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒

Assertion (A): CCIR-B system has 625 scanning lines per frame and 2 : 1 interlace.

Reason (R): The aspect ratio is 4 : 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A direct current can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a standard resistance
by dc potentiometer in conjunction with volt ratio box
none of the above

⇒ In a phase discriminator f_c, is the IF to which primary circuit is tuned. Consider the following statements: The primary and secondary voltages are

exactly 90° out of phase when input frequency is f_c
more than 90° out of phase when input frequency is higher than f_c
less than 90° out of phase when input frequency is lower than f_c

Which of the above statements is correct?
1 only
1 and 2
1, 2 and 3
2 and 3

⇒

Assertion (A): Intrinsic resistivity of silicon is lower than that of germanium.

Reason (R): Magnitude of free electron concentration in germanium is more than that of silicon.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true