Question is ⇒ The noise generated by a resistor depends upon, Options are ⇒ (A) its resistance value, (B) its operating temperature, (C) both its resistance value and operating temperature, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The noise generated by a resistor depends upon, Options are ⇒ (A) its resistance value, (B) its operating temperature, (C) both its resistance value and operating temperature, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The noise generated by a resistor depends upon
A.	its resistance value [Wrong Answer]
B.	its operating temperature [Correct Answer]
C.	both its resistance value and operating temperature [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 6 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Some desirable features of a computer communication network are

It should accept an intended transmission without excessive delay
The data arriving at a receiving point should be processed rapidly
When a transmission calls for a response, the delay of response should be minimum.

Which of the above are true?
1 and 2 only
1 and 3 only
1, 2, 3
2 and 3 only

⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is
100 KHz
200 KHz
50 KHz
150 KHz

⇒ Consider a control system shown in given figure. For slight variation in G, the ratio of open loop sensitivity to closed loop sensitivity will be give
1 : (1 + GH)
1 : (1 + GH)^{- 1}
1 : (1 - GH)
1 : (1 - GH)^{- 1}

⇒ At a P-N junction, the potential barrier is due to the charges on either side of the junction, which consists of
fixed donor and acceptor ions
majority carriers only
minority carriers only
both majority and minority carriers

⇒ The 2732 is 4096 x 8 EPROM. How many address lines does it have?
12
24
50
100

⇒ In an air cored coil, a current of 0.7 A causes a flux of 5 x 10^-6 Wb. If the core is made of cast iron and the coil is similar, the same current can set up a flux of about
5 x 10^-6 Wb
5 x 10^-8 Wb
10^-2 Wb
5 x 10^-4 Wb

⇒

Assertion (A): FET has characteristics very similar to that of pentode.

Reason (R): Both FET and pentode are voltage controlled devices.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A wave is frequency modulated with an index of 0.1 and its frequency is multiplied by 8 times, the modulation index is
not changed
decreased 8 times
increased 4 times
increased 8 times

⇒ The advantage of using crystal oscillator is that it
requires low d.c. supply voltage
works at high frequency
gives high output voltage
gives constant frequency of oscillations

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be
R/3
3 R
R/9
9 R

⇒ A depletion type NMOS is operated in enhancement mode. V_p = - 4 volts. For V_GS = + 3 volts as V_DS is increased, I_D becomes nearly constant when V_ps equals
1 volt
3 volts
4 volt
7 volts

⇒ It is required to measure angular position. Out of the transducers

Circular potentiometer
LVDT
E pick up
Synchro

The proper devices are
1, 2, 3, 4
2 and 3
1, 2, 4
1 and 4

⇒ Which of the following is not an assembler directive in 8085?
D S
D B
D Q
E Q U

⇒ The purpose of impedance matching in an amplifier circuit is to achieve
high efficiency
reduce distortion
maximum power transfer
none of the above

⇒ The characteristic impedance of a cable is about
300 Ω
50 Ω
5 Ω
2 Ω

⇒ A 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V. It meets standard linearity then resolution in percent and volts.
3% 7 V
6.4 V, 2%
0.1%, 1.57 V
1.57%, 0.1 V

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease

Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒ When a current carrying conductor is brought into magnetic field, the force that moves the conductor depends upon
the value of current
the weight of the conductor
the direction of the conductor
none of the above

⇒ In case of a transistor amplifier the emitter resistance R_e is removed
the gain of the amplifier will reduce
heat sink will not be required
Q-point will become unstable
base to emitter function will be less forward biased

⇒

Assertion (A): Master slave JK flip flop is commonly used in high speed synchronous circuitry

Reason (R): Master slave JK flip flop uses two JK flip flops in cascade.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In position control system the device used for providing rate feedback voltage is
potentiometer
synchro-transmitter
synchro-transformer
tacho generator

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ Measurement of non-electrical quantity involves the following subsystems

Amplifier block
Display block
Instrumentation block
Transducer block

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ The phase angle curve of G(jω) H(jω) can be drawn
by adding the phase angle curves of individual factors
by subtracting the phase angle curves of individual factors
by multiplying the phase angle curves of individual factors
by dividing the phase angle curves of individual factors

⇒ c(t) and m(t) are used to generate an AM signal. The modulation index of the generated AM signal is 0.5 then the quant
42737
42739
42738
42743

⇒

Assertion (A): Microprocessor 8085 has 16 address bus lines and 8 data bus lines.

Reason (R): Address bus in 8085 is unidirectional.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε_r = 9). The magnitude of the reflection coefficient is
0
0.3
0.5
0.8