Question is ⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be, Options are ⇒ (A) 32 μ sec, (B) 20 μ sec, (C) 21 μ sec, (D) 22 μ sec, (E) , Leave your comments or Download question paper.

Question is ⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be, Options are ⇒ (A) 32 μ sec, (B) 20 μ sec, (C) 21 μ sec, (D) 22 μ sec, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The multiplication time for 10-bit numbers with 1 MHz clock will be
A.	32 μ sec [Wrong Answer]
B.	20 μ sec [Wrong Answer]
C.	21 μ sec [Wrong Answer]
D.	22 μ sec [Correct Answer]
View Answer 8 -6 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If x^k is one sided to the ri
TRUE
FALSE

⇒ In MTI radar, clutter means
echos from moving targets
echos from stationary targets
atmospheric noise
thermal noise

⇒

Assertion (A): Inverters and choppers use fast switching thyristors

Reason (R): Fast switching SCR has low turn off time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The phase angle curve of G(jω) H(jω) is drawn by adding the phase angles of individual factors.
TRUE
FALSE

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ A multivibrator can be used as a
cavity resonator
harmonic generator
wave form modifier
any of the above

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒ The region between a pin of parallel perfectly conducting planes of infinite extent is y and z directions is partially filled with a dielectric as shown be
-2
2
0
1

⇒ In h parameter representation, the independent variables are
I₁ and V₂
I₂ and V₁
V₁ and V₂
I₁ and I₂

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒ If i_b is plate current, e_b is plate voltage and e_c is grid voltage the v-i curve of a vacuum triode
0.5 and 1
- 2 and 1
30 and 1
30 and 1.5

⇒ (1 2 1)_x = (1 0 0)₄ Then x is equal to
2
3
5
does not exist

⇒ The hexadecimal number 5 F is equal to binary number
1010011
1011001
1010101
1011111

⇒ If ω is the frequency of modulating voltage in FM, the modulation index is proportional to
ω
1/ω
ω
1/ω

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L

⇒ Consider the following statemen
1 only
2 only
1 and 2
2 and 3

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
5 V
10 V
15 V
30 V

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ Surge current rating of an SCR is
the maximum repetitive surge current in which the SCR can withstand
the maximum non-repetitive surge current in which the SCR can withstand
the maximum repetitive or non repetitive surge current in which the SCR can withstand
the maximum surge current in which the SCR can withstand if both surge current and steady current exist together

⇒ A coil of resistance R and inductance L is connected in series with 5 μF capacitor. The source frequency is equal to resonance frequency and circuit current is 0.5 A. Another 5 F capacitor is connected in parallel with the above capacitor. The circuit current will be
0.5 A
more than 0.5 A
less than 0.5 A
0.5 A or less

⇒ Which of the following are universal gates?

NAND
NOR
XOR

Select the correct answer from the codes given below:
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ ALU 1C 74181 can accept two words each having
2 bits
4 bits
8 bits
16 bits

⇒ The statement IMPLICIT INTEGER (A - F) in FORTRAN identifies
all variable names which begin with A, B, C, D, E or F as being of integer type
all character names which begin with A, B, C, D, E, or F as being of integer type
all variable names which begin with A and have 6 characters
none of the above

⇒ In an FM signal, the power
increases as the modulation index increases
reduces as the modulation index increase
increases as the modulation index decreases
remains constant when the modulation index increases

⇒ The noise at the input to an ideal frequency detector is white. The detector is operating above threshold. The power spectral density of the noise at the output is
raised-cosine
flat
parabolic
Gaussian

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒

Assertion (A): The resolution of a DAC depends on the number of bits

Reason (R): Low resolution leads to fine control.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true