Question is ⇒ The most commonly used logic family is, Options are ⇒ (A) ECL, (B) TTL, (C) CMOS, (D) PMOS, (E) , Leave your comments or Download question paper.

Question is ⇒ The most commonly used logic family is, Options are ⇒ (A) ECL, (B) TTL, (C) CMOS, (D) PMOS, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The most commonly used logic family is
A.	ECL [Wrong Answer]
B.	TTL [Correct Answer]
C.	CMOS [Wrong Answer]
D.	PMOS [Wrong Answer]
View Answer 3 -10 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ If there is phase error in the carrier signal for the detection of SSB signals, then
the output gets reduced, but a phase distortion results
the output is not reduced, but a phase distortion results
the output is not reduced, and also no distortion
the output is reduced, no phase distortion

⇒ Ferrites are
ferromagnetic materials
ferrimagnetic materials
ferroelectric materials
ferri-ferromagnetic materials

⇒ At room temperature the number of conducting electrons in an intrinsic semiconductor
is almost equal to the number of valence electrons
is about half the number of valence electrons
is small as compared to the number of valence electrons
is a very small fraction of the number of valence electrons

⇒ Drain feedback bias is often used with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ Which of the following logic family is fastest of all?
TTL
RTL
DCTL
ECL

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
180
120
90
60

⇒ A short-circuit is that which is
used short pieces of wire
goes only a short distance
is used for dimming light
offer very low resistance path for current to flow

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A 1000 kHz carrier wave modulated 40% at 40000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulator after transmission through the circuit?
0.4
0.2
0.27
0.54

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒ As the ratio R_f/R_L increases the efficiency of a rectifier increases.
TRUE
FALSE

⇒ Negative feedback reduces noise originating at the amplifier input.
TRUE
FALSE

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ A land line telemetry system is suitable for distance upto
about 1 km only
about 10 km only
about 100 km only
any of the above

⇒ In 8085 microprocessor, if interrupt service requests have been received from all of the following interrupts, then which one will be serviced first?
RST 5.5
RST 6.5
RST 7.5
None

⇒ The number of distinct Boolean expression of 4 variables is
16
256
1024
65536

⇒ The range of values of a and b for which the linear time invariant system with impulse respon
|a| > 1, |b| > 1
|a| < 1, |b| < 1
|a| < 1, |b| > 1
|a| > 1, |b| < 1

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

⇒ Among the various modulation systems, the most favoured from the point of linearity of modulation and efficiency is
anode or collector modulation
central grid modulation
screen grid modulation
modulated oscillators

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ Consider the following statements :

Tellegen's theorem is applicable to any lumped networks.
The reciprocity theorem is applicable to linear bilateral networks.
Thevenin's theorem is applicable to two- terminal linear active networks.
Norton's theorem is applicable to two-terminal linear active networks.

Which of these statement are correct?
1, 2, and 3
1, 2 and 4
1, 2, 3 and 4
3 and 4

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
20 ∠20° A
10 ∠20° A
14.14 ∠20° A
10 ∠- 20° A

⇒ The number of select lines in a 16 : 1 multiplexer are
4
3
2
1

⇒ Consider the following statements about Infix and Post fix notations in Pascal

In Infix notation operators appear between the operands on which they operate.
In Post fix notation operators appear after the operand.
The Infix expression A + B - C + D will appear as AB + C - D + in post fix notation.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ For the amplifier in figure, β = 800. The mid-band voltage gain V₀/V_{i0
< 1
≈ 1
800}

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency, the dynamic resistance is
1 Ω
10 Ω
100 Ω
more than 100 Ω