Question is ⇒ The minimum decimal equivalent of the number 11C0 is, Options are ⇒ (A) 183, (B) 194, (C) 268, (D) 269, (E) , Leave your comments or Download question paper.

Question is ⇒ The minimum decimal equivalent of the number 11C0 is, Options are ⇒ (A) 183, (B) 194, (C) 268, (D) 269, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The minimum decimal equivalent of the number 11C0 is
A.	183 [Wrong Answer]
B.	194 [Wrong Answer]
C.	268 [Correct Answer]
D.	269 [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following instruction modes does not exist in microprocessor 8085?
Inherent
Immediate
Absolute
Indirect

⇒ In plotting line spectrum
a graph of complex number F_n versus frequency is plotted
a graph of |F_n| versus frequency is plotted
a graph of the angle of F_n versus frequency is plotted
two graphs viz |F_n| versus frequency and the phase angle of Fn versus frequency are plotted

⇒ A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by
a shunt capacitance at the discontinuity
a shunt inductance at the discontinuity
a shunt resistance at the discontinuity
none of the above

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ Consider the following two statements about the internal conditions in an n-channel MOSFET operating in the active re
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, but S2 is not a reason for S1
Both S1 and S2 are true, and S2 is a reason for S1

⇒ 1011₂ x 101₂ = __________ ₁₀
55
45
35
25

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒ Zener diode is invariably used with
forward bias
reverse bias
either (a) or (b)
zero bias

⇒ For an m-derived filter, attenuation is infinite when f = f_∞.
TRUE
FALSE

⇒ Compared to a p-n junction with N_A = N_D = 10¹⁴/cm³, which one of the following statements is TRUE for a p-n junction with N_A = N_D = 10²⁰/cm³?
Reverse breakdown voltage is lower and depletion capacitance is lower
Reverse breakdown voltage is higher and depletion capacitance is lower
Reverse breakdown voltage is lower and depletion capacitance is higher
Reverse breakdown voltage is higher and depletion capacitance is higher

⇒ In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the maximum frequency deviation is
175 Hz
525 Hz
3 Hz
58.33 Hz

⇒ Class C amplifier is suitable for
a narrow frequency band
a wide frequency band
audio frequencies
either (b) or (c)

⇒ EPROM can be
UVPROM
EEPROM
both UVPROM and EEPROM
none of the above

⇒ Which of the following is λ/2 length?
Marconi
Hertz
Parabolic
Yagi-uda

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ CCIR system B employs
625 lines
625 lines with 2 : 1 interlace
625 lines with 4 : 1 interlace
500 lines with 2 : 1 interlace

⇒ If a number of odd functions are added, the resultant sum is
even function
odd funtion
either even or odd function
mixture of odd amd even functions

⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1

⇒ Consider the following statements about 'Functions' in C

A function can be called any number of times.
A function gets called when the function name is followed by a semicolon.
The order in which functions are defined in a program and the order in which they are called must be the same.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,
stationary
ergodic
Gaussian
BIBO stable

⇒ Which one is correct option?

A pure capacitor never dissipates energy, but only stores.
Capacitor can store finite amount of energy even cunent is zero.
The current through a capacitor is zero if voltage across it d.c.
Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
q_c(0^-) = q_c(0⁺)

5, 4, 3, 2
3, 4, 1, 2
2, 4, 3, 1
1, 2, 3, 4, 5

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ In an intrinsic semiconductor, the intrinsic charge concentration at any absolute temperature T is proportional to
T
T²
T³
T⁴

⇒ The distance between target and radar is reduced to half. Power received increases by
42751
42739
4 times
16 times

⇒ The number of valence electrons in donor impurity are
5
4
3
1

⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?
35 W
60 W
85 W
100 W

⇒ Which of the following is not a legal subscript?
J + 2
JA - 4
-3
3^* IA - 2

⇒ If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is
1 ohms
10 ohms
25 ohms
100 ohms