Question is ⇒ The materials having low retentivity are suitable for making, Options are ⇒ (A) temporary smagnets, (B) weak magnets, (C) permanent magnets, (D) both temporary and permanent magnets, (E) , Leave your comments or Download question paper.

Question is ⇒ The materials having low retentivity are suitable for making, Options are ⇒ (A) temporary smagnets, (B) weak magnets, (C) permanent magnets, (D) both temporary and permanent magnets, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The materials having low retentivity are suitable for making
A.	temporary smagnets [Correct Answer]
B.	weak magnets [Wrong Answer]
C.	permanent magnets [Wrong Answer]
D.	both temporary and permanent magnets [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following: Energy storage capability of basic passive elements is due to the fact that

resistance dissipates energy
capacitance stores energy
inductance dissipates energy

Which of the above is/are correct?
1, 2, and 3
1 and 3
3 only
1 and 2

⇒ What would be the reading of voltmeter as shown in below figure. The voltmeter has a 0-1 V scale and is a 20000 Ω/V me
0.4545 V
0.082 V
0.82 V
4.54 V

⇒ In a rectangular waveguide there is one half wave variation of electric field across the narrow dimension and two half wave variations of electric field across wider dimension. The dominant mode is
TM₁₂
TE₁₃
TE₂₁
TM₂₅

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in intensity of optical illumination results in
a change in o.c voltage
a change in s.c current
decrease in resistance
increase in resistance

⇒ Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
Exponential amplifier

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ The series element of a band stop filter is
capacitive
inductive
parallel combination of L and C
series combination of L and C

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ The attenuation in waveguides near the cut off frequency is
very low
very high
medium
zero

⇒ A geostationary satellite is one which
hangs motionless in space about 36000 km about Earth
travels around the Earth in 24 hours
remains stationary above the Earth
appears stationary to everybody on Earth

⇒ A logical expression Y = A + AB is equal to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒ When a dc chopper feeds an RLE load, the load current, during steady state operation
remains constant
varies between maximum and minimum values
may remain constant or vary
is constant if R is constant

⇒

Assertion (A): Data communication using digital data must be very accurate.

Reason (R): In analog signals redundancy is available but in digital signals redundancy is not available.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ Efficiency of a half wave diode rectifier is less than 40%.
TRUE
FALSE

⇒ The following circuit is implementation of

Sum of full adder

Carry of half adder

Difference of full subtractor

<
(i) only
(iii) only
(ii) only
(i) and (ii)

⇒ In the circuit of figure for sinusoidal input the waveform of the output will be as show
figure A
figure B
figure C
figure D

⇒ In a JFET, the drain current is maximum when
V_GS = 0
V_GS is not zero but is slightly negative
V_GS is negative
V_GS is negative and equal to V_DS

⇒ Which of the following is not an interrupt line in 8085?
TRAP
RST 5.5
RST 7.5
RST 9.5

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ In an RC series circuit R = 100 Ω and X_C = 10 Ω. In this circuit
the current and voltage are in phase
the current leads the voltage by about 6°
the current leads the voltage by about 84°
the current lags the voltage by about 6°

⇒ An n channel depletion type MOSFET has
lightly doped p substrate and highly doped n source and drain
highly doped p substrate and highly doped n source and drain
highly doped p substrate and lightly doped n source and drain
lightly doped n substrate and highly doped n source and drain

Match the following:

	List I (Operator in C)		List II (Priority of Operation)
A.	!	1.	1
B.	< >	2.	2
C.	∗	3.	3
D.	=	4.	4

A-1, B-2, C-3, D-4
A-1, B-3, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4

⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is
100 KHz
200 KHz
50 KHz
150 KHz

⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω

⇒ EEPROM is also known as
UVPROM
EAPROM
both UVPROM and EAPROM
none of the above

⇒ Which of the following statement is correct?
Decimal 9 is represented as 1011 in Excess-3 code
Decimal 9 is represented as 1001 is BCD code
Decimal 10 is represented as 1100 is Gray code
Decimal 10 is represented as 1001 in binary code