Question is ⇒ The main drawback in the performance of shunt peaked wide band amplifier is, Options are ⇒ (A) two low gain at low frequency, (B) poor phase response, (C) reduce frequency at middle frequency, (D) that the maximum gain of the stage is small, (E) , Leave your comments or Download question paper.

Question is ⇒ The main drawback in the performance of shunt peaked wide band amplifier is, Options are ⇒ (A) two low gain at low frequency, (B) poor phase response, (C) reduce frequency at middle frequency, (D) that the maximum gain of the stage is small, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The main drawback in the performance of shunt peaked wide band amplifier is
A.	two low gain at low frequency [Wrong Answer]
B.	poor phase response [Correct Answer]
C.	reduce frequency at middle frequency [Wrong Answer]
D.	that the maximum gain of the stage is small [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The frequency deviation of a FM signal produced from PM is
identical to that of FM signal produced by direct method
larger than that of a FM signal produced by direct method
directly proportional to the peak amplitude and the frequency of modulating signal
directly proportional to the peak amplitude of the modulating signal

⇒ A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
0101 and 5
0101 and 10
1010 and 5
1010 and 10

⇒ All poles and zeros of a driving point immittance function of an L-C network
should lie on the jω axis
should lie on the +ve real axis
should lie on the - ve real axis
can lie anywhere in s-plane

⇒ What is the gray code word for EX-OR the binary number 101011?
101011
110101
111110
11111

⇒

Assertion (A): It is not desirable to drive a transistor into hard saturation in high speed switching circuits.

Reason (R): It may not be possible to bring it back to cutoff state, if it is driven into hard saturation.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ A series RLC circuit is at resonance at 200 Hz. If capacitance is increased to four times, the circuit will be in resonance at
200 Hz
400 Hz
100 Hz
800 Hz

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be
1011
110
10
1

⇒ The addition of n type impurity to intrinsic material creates allowable energy levels.
slightly below conduction band
slightly above conduction band
slightly below valence band
slightly above valence band

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The ratio of tangential component of electric field at the surface of a conductor and the linear current density resulting from this field is __________ impedance
characteristic
critical
surface
polarizing

⇒ In 8156, the lower times byte is addressed with 24 H, and the upper times byte with
20 H
23 H
24 H
25 H

⇒ In the circuit shown in the given figure, R_L will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω

⇒ In a valence crystal, the valence electrons
are not shared
are shared between neighbouring atoms
are shared by all atoms
any of the above

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ What will be conversion rate for a counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
125
125 x 10³
125 x 10⁶
None

⇒ In a series RLC circuit for lower frequency power factor is ________
leading, Lagging
lagging, Leading
independent of frequency
same

⇒ A capacitor used for power factor correction in single- phase circuit decreases
the power factor
the line current
both the line current and the power factor
the line current and increases power factor

⇒ In the given figure, the input frequency is such that R = X_C.
v₀ lags v_i by 45°
v₀ lags v_i by 90°
v₀ leads v_i by 45°
v₀ leads v_i by 90°

⇒ In a JFET
the source gate junction is forward biased and gate drain junction is reverse biased
both the junctions are forward biased
both the junctions are reverse biased
the source gate junction is reverse biased and gate drain junction is forward biased

⇒ High purity copper is obtained by
rolling casting
casting
electrolytic refining
induction heating

⇒ A load Z_L = R_L + jX_L is to be matched using an ideal transformer to generator of internal impedance Z_S = R_S + jX_S. The ratio of transformer required is __________ .
|Z_S|/|Z_L|
R_L/R_S
R_L/Z_S
|Z_L|/R_S

⇒ In 8085 microprocessor, the RST 5.5 interrupt service routine start from location
0020 H
0024 H
0028 H
002 CH

⇒

Assertion (A): A p-n junction is used as rectifier.

Reason (R): A p-n junction has low resistance in forward direction and high resistance in reverse direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A message signal x(t) is amplitude modulated with carrier c(t2ω
3ω
1ω
0.5ω

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math