Question is ⇒ The main advantage of DM over PCM is, Options are ⇒ (A) less bandwidth, (B) less power, (C) simple circuit, (D) better S/N ratio, (E) , Leave your comments or Download question paper.

Question is ⇒ The main advantage of DM over PCM is, Options are ⇒ (A) less bandwidth, (B) less power, (C) simple circuit, (D) better S/N ratio, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The main advantage of DM over PCM is
A.	less bandwidth [Wrong Answer]
B.	less power [Wrong Answer]
C.	simple circuit [Correct Answer]
D.	better S/N ratio [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following effects is used in measurement of magnetic flux?
Hall effect
Seeback effect
Piezo electric effect
Photoelectric effect

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping

⇒ The units of the spectrum obtained be Fourier transforming the covariance function of a stationery Stochastic Process is
Power per Hz
energy per Hz
Power per sec
Energy per second

⇒ Tropospheric scatter propagation is not subject to any fading.
TRUE
FALSE

⇒ Which memory is available in all technologies?
PROM
EEPROM
ROM
EPROM

⇒ Which of the following statement is false?
A stationary process is always a ergodic process
A ergodic process is always a stationary random process
It is possible to have a stationary random
None of the above

⇒ A signal m(t) = 5 cos 2p 100 t frequency modulates a carrier. The resulting FM signal
0.1 kHz
6 kHz
3.2 kHz
100 kHz

⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
ω₁ = ω₀ + bandwidth
ω₁ = ω₀ + 0.5 (bandwidth)
ω₁ = ω₀ - 0.5 (bandwidth)
ω₁ = ω₀ + bandwidth

⇒ For the floating point numbers 1.81 x 10^-29 and 0.0152 x 10¹⁸ the normalised forms are
0.181 x 10^-28 and 0.152 x 10¹⁷respectively
18.1 x 10^-30 and 0.152 x 10¹⁷ respectively
0.181 x 10^-28 and 1.52 x 10¹⁶ respectively
None of the above

⇒ It is required to study transients during switching process. Which CRO should be preferred?
Ordinary CRO
Dual beam CRO
Dual trace CRO
Storage oscilloscope

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ Brownian motion is
random emission of electrons in vacuum tubes
thermal motion of electrons in a resistance
random diffusion of holes and electrons in semi- conductors
both (b) and (c)

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒ In a vibrating reed frequency meter the natural frequency of two adjacent reeds have a difference of
0.25 Hz
0.5 Hz
1.25 Hz
1 Hz

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ A circuit which cannot demodulate SSB is
balanced modulator
product detector
BFO
phase discriminator

⇒

Assertion (A): Derivative control action cannot be used alone.

Reason (R): Derivative control action is effective only during transient periods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ For a given carrier wave, maximum undistorted power is transmitted when value of modulation is
1
0.8
0.5
0

⇒ While AM has __________ frequencies, FM has __________ number of sidebands.
2, 3
3, 3
3, 5
3, infinite

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ADI A4H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1

⇒ For a core having a relative permeability μ_r, magnetic dipole moment per unit volume M and field strength H, the flux density B is
B = μ_r (H + M)
B = μ₀ (H + M)
B = μ₀μ_r (H + M)
B = μ₀μ_r (H - M)

⇒ The main advantage of a crystal oscillator
can oscillate any frequency
gives a high output voltage
frequency of oscillation is almost constant
can operates at a low dc voltage

⇒ In a class C operation
V_CC is much larger than V_CE(sat)
V_CC is much smaller than V_CE(sat)
V_CC and V_CE(sat) are nearly equal
none of the above

⇒ The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistanc
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ Which one of the following is transferred locking electron device C antenna?
BARITT diode
IMPATT diode
Gunn diode
Step recovery diode

⇒ The phase angle curve of G(jω) H(jω) can be drawn
by adding the phase angle curves of individual factors
by subtracting the phase angle curves of individual factors
by multiplying the phase angle curves of individual factors
by dividing the phase angle curves of individual factors