Question is ⇒ The main advantage of CC amplifier is, Options are ⇒ (A) High input impedance and low output impedance, (B) Low input impedance and high output impedance, (C) High voltage gain, (D) High current gain, (E) , Leave your comments or Download question paper.

Question is ⇒ The main advantage of CC amplifier is, Options are ⇒ (A) High input impedance and low output impedance, (B) Low input impedance and high output impedance, (C) High voltage gain, (D) High current gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The main advantage of CC amplifier is
A.	High input impedance and low output impedance [Correct Answer]
B.	Low input impedance and high output impedance [Wrong Answer]
C.	High voltage gain [Wrong Answer]
D.	High current gain [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A uniform wave have components
in the perpendicular direction E existing while H is zero
in the direction of propagation E existing while H is zero
E and H are zero in direction perpendicular to direction of propagation
E and H existing only in direction perpendicular to direction of propagation

⇒ For the network of figure, z_{115/3 Ω
3/2 Ω
2 Ω
2/3 Ω}

⇒ If V_in is 0.99 V, what is the digital output of the ADC 0801 after INTER goes low?
0011 0011
0101 1111
0111 1100
1111 1111

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
not possible

⇒ 23.6₁₀ = __________ ₂
11111.1001
10111.1001
111.101
10111.1

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒ Choose the appropriate turn on and turn off time of a FET
1 ns, 10ns
6 ns, 18ns
4 ns, 8 ns
10 ns, 10 ns

⇒ If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is
0
1
∞
2

⇒ A voltage DAC is generally slower than current DAC
because of more accuracy
because of higher resolution
because of response time of op-amp current to voltage converter
none of the above

⇒ Divergence of curl A is
∇ . (∇ x A) = 1
∇ . (∇ x A) = 0
∇ . (∇ x A) = ∇
∇ . (∇ x A) = - ∞

⇒ If the number of ways an event may result ins analysed into m successes and n failures, each equally likely to occur, the probability of success in a single trial is m( m + n)
TRUE
FALSE

⇒ The Boolean expression Y = (A + B + AB) C then Y will be equal to
AC
BC
C
none

⇒ Effective address is calculated by adding or subtracting displacement value to
immediate address
Relative address
absolute address
base address

⇒ If current is less than 20 mA and time of contact is very small, the effect of current on human body is likely to be temporary.
TRUE
FALSE

⇒ The baud rate is
not equal to signalling rate
always equal to bit transfer rate
equal to twice the bandwidth of an ideal channel
equal to half the bandwidth of ideal channel

⇒ Which of the following statement is correct?
A FET is a current controlled device
A BJT is always reverse biased
The semi-conductor material of the gate in an N-channel JFET is p-type
JFET has higher input impedance than MOSFET

⇒ The ability of a radio receiver to discriminate between different input signals and to accept only one definite signal is called its
sensitivity
attenuation
selectivity
modulation

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ Consider the following stateme
1, 4 are correct
1 and 2 correct
1, 2, 3 are correct
2, 3, 4 are correct

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒ j⁶ =
j
j²
j³
- j

⇒ The effective electrical length of an antenna is __________ its physical length
greater than
equal to
less than
none of the above

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒ Which interrupts are masked?
5.5
6.5
7.5
None

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ A satellite link uses different frequencies for receiving and transmitting in order to
avoid interference from terrestrial microwave links
avoid interference between its powerful transmitted signal and weak in coming signal
minimise free-space losses
maximise antenna gain

⇒ For a symmetrical network
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ z₂₂ and z₁₂ = z₂₁
z₁₁ z₁₂ - z₁₂² = 0

⇒ The binary number 101100.110 in octal number will be
152.6
154.6
145.6
174.6

⇒ If antenna diameter is increased four times, the maximum range is increased by a factor of
2
2
4
0.2

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance