Question is ⇒ The magnitude response of a normalised Butterworth low pass filter is, Options are ⇒ (A) linear starting with value of unity at zero frequency and 0.707 at cut off frequency, (B) non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency, (C) linear upto cut off frequency and nonlinear thereafter, (D) nonlinear upto cut off frequency and linear thereafter, (E) , Leave your comments or Download question paper.

Question is ⇒ The magnitude response of a normalised Butterworth low pass filter is, Options are ⇒ (A) linear starting with value of unity at zero frequency and 0.707 at cut off frequency, (B) non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency, (C) linear upto cut off frequency and nonlinear thereafter, (D) nonlinear upto cut off frequency and linear thereafter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The magnitude response of a normalised Butterworth low pass filter is
A.	linear starting with value of unity at zero frequency and 0.707 at cut off frequency [Correct Answer]
B.	non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency [Wrong Answer]
C.	linear upto cut off frequency and nonlinear thereafter [Wrong Answer]
D.	nonlinear upto cut off frequency and linear thereafter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ JFET has __________ degree of isolation between input and output, and a __________ noise figure.
low, low
high, high
low, high
high, low

⇒ A circular waveguide has an infinite set of TE and TM modes.
TRUE
FALSE

⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
1p rad/m
2p rad/m
0.2p rad/m
0.1p rad/m

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current

⇒ An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is
1 kHz
7.5 kHz
75 kHz
100 MHz

⇒ Two independence parameters Z₁₁ and Z₁₂ of the two-port network in the figure
Z₁₁ = 2.75 Ω and Z₁₂ = 0.25 Ω
Z₁₁ = 3 Ω and Z₁₂ = 0.5 Ω
Z₁₁ = 3 Ω and Z₁₂ = 0.25 Ω
Z₁₁ = 2.25 Ω and Z₁₂ = 0.5 Ω

⇒ A moving iron instrument can be used for dc as well as ac.
TRUE
FALSE

⇒ The log magnitude plot of the given figure is
type 0 system
type 1 system
type 2 system
either type 0 or type 1 system

⇒ If the potential functions V₁ and V₂ satisfy Laplace's equation within a closed region and assume the same values on its surface, then which of the following is correct?
V₁ and V₂ are identical
V₁ is inversely proportional to V₂
V₁ has the same direction as V₂
V₁ has the same magnitude as V₂ but has different direction

⇒ Negative feedback lowers the cut off frequency and increase the upper cut off frequency of amplifier.
TRUE
FALSE

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒

Assertion (A): If an atom of polarizability a is placed in homogeneous field E, the energy stored is 0.5 aE².

Reason (R): Capacitance of an isolated conducting sphere R in vacuum is 4 p∈₀ R farads.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Hue of a colour means
amount of light energy received by eye
predominant spectral purity of colour light
amount of other colours present
none of the above

⇒ The circuit shown below is functionally equivalen
NOR gate
OR gate
EX-OR gate
NAND gate

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The voltage multiplication is
25
50
125
250

⇒ An AM wave is given by s(t)_AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is
0.5
0.58
0.3
0.8

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ Consider an input x(t) as sh
-2 < t < 6
0 < t < 11
-2 < t < 5
2 < t < 6

⇒ Monostable multivibrator is called one-shot or single-shot circuit because it
can be used once
can be used single and not with other circuits.
always returns by itself to its single stable state
changes to quasistable for a fixed period of time upon receipt of triggering signal.

⇒ A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum
at t = RC
at t = ∞
at t = 0⁺
none of the above

⇒ Which binary addition is incorrect?
1101.1 + 1011.1 = 11001.0
101101 + 1101101 + 1100011
0.0011 + 0.1110 + 1.0001
1100.001 + 1011.011 = 10111.100

⇒ The unit of permeability is
T
Wb
H/M
H

⇒ Binary 1000 multiplied by binary 1000 gives
10000
100000
1000000
10000000

⇒ A 12 bit ADC is operating with 1 μs clock period. Total conversion time is 14 μs. ADC is
flash type
counting type
integrating type
successive approximation type

⇒ For the K map in the given figure the simplified Boolean expressio
A C + A D + ABC
A C + A D + ABC
A C + A D + ACD
A C + A D + AB C

⇒ For a given voltage four heating coils will give maximum heat when connected
in parallel
in series
with two parallel pairs in series
with one pair in parallel and the other two in series

⇒ Current having waveform in figure flows through 10 Ω resistance. Average powe
1000 W
500 W
333.3 W
250 W

⇒ An electron shell corresponding to principal quantum number n can contain a maximum of
n² electrons
2n² electrons
2n electron
n³ electron

⇒ Modified Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes