Question is ⇒ The magnitude of transport lag factor is always zero., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ The magnitude of transport lag factor is always zero., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The magnitude of transport lag factor is always zero.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085, out of interrupts given below, one particular interrupts is quite different from others, This interrupt is
RST 5.5
RST 6.5
RST 7.5
none of these

⇒ Consider an incremental vector element of length ΔL and angle between an electric field E and ΔL s cos &the
In the direction of E
In opposite direction of E
In the angle of 45° with E
In the angle of 60° with E

⇒ The system in the given figur
type 0 system
type 1 system
type 2 system
type 3 system

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ In a full wave diode rectifier circuit each diode carries current for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ If f₁ (t) and f₂ (f) are two functions of time and a and b are constants, then
L [af₁(t) + bf₂(t)] = aF₁(s) + bF₂(s)
L [af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)
L [af₁(t) + bf₂(t)] =[aF₁(s)]/[bF₂(s]
None of the above

⇒

Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The number of tightly bound electrons in silicon atom are
14
10
6
4

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is __________ .
0.25
0.5
0.75
1

⇒ For free space propagation
γ = a + jβ
γ = jβ
γ = a
a = β = 0

⇒ The expression Y (A, B, C) = ∑m (1, 3, 5, 6) is to realized using a multiplexer. Then
use 8 : 1 multiplexer and ground input lines 1, 3, 5, 6
use 8 : 1 multiplexer and ground input lines 0, 2, 4, 7
use 8 : 1 multiplexer and ground input lines 0, 1, 2, 3
use 8 : 1 multiplexer and ground input lines 4, 5, 6, 7

⇒ In a purely resistive circuit the instantaneous power varies from zero to maximum twice in each cycle.
TRUE
FALSE

⇒ For an RC driving point impedance function, the poles and zeros
should alternate on real axis
should alternate only on negative real axis
should alternate on imaginary axis
none of the above

⇒ Gain margin and phase margin can be determined from Bode plots as well as Nyquist plot.
TRUE
FALSE

⇒ In a solar cell, the photovoltaic voltages is the voltage at which the resultant current is
positive
zero
negative
rated current

⇒ In a dual converter both converters work as rectifiers.
TRUE
FALSE

⇒

Assertion (A): CCIR-B system has 625 scanning lines per frame and 2 : 1 interlace.

Reason (R): The aspect ratio is 4 : 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following statements about constants in 8085

The assembler treats 64 H as hexadecimal constant.
The assembler treats 154 as binary constant.
The assembler treats 540 as octal constant.
The assembler treats 138 as decimal constant.

Which of the above are correct?
1, 2 and 3 only
1, 3 and 4 only
1 and 3 only
2 and 4 only

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ Which of the following methods is used for solving differential equations numerically?
Runge-Kutta method
Gauss-elimination method
Newton-Raphson method
Any one of these

⇒ The power requirements of a DRAM in active and stand by modes is about
350 mW and 5 mW respectively
350 mW each
5 mW each
350 mW and 100 mW respectively

⇒ A function f(t) = k e^at is __________ for (a > 0).
stable
unstable
marginal
none

⇒ In the given fi
42737
42739
2
1

⇒ The mobility of e^- for Ge and Si respectively is
1.66, 2.5
2.5, 1.66
2.7, 2.33
2.33, 2.7

⇒ Choose the correct statement/statements :
In case of an antenna, the antenna resistance and loss resistance are not two different quantities.
The loss resistance includes loss by eddy currents, improper earth connections, insulation leakages, etc., but not I²R losses.
Radiation resistance varies directly as square-root of frequency
None

⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease

⇒ The main function of a balanced modulator is to
produce balanced modulation of a carrier wave
produce 100% modulation
suppress carrier signal in order to create a single-sideband or double sideband
limit noise picked by a receiver

⇒ Which of the following statements in FORTRAN 77 is non executable?
GO TO
RETURN
STOP
PARAMETER

⇒ ALU carries out
arithmetic operations
logic operations
both arithmetic and logic operations
none of the above

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE