Question is ⇒ The logic represented by the abbreviation ECL is, Options are ⇒ (A) Emitter Coupled Logic, (B) Electron Carrier Logic, (C) Encoding Clock Logic, (D) Electrostatic Channel Logic, (E) , Leave your comments or Download question paper.

Question is ⇒ The logic represented by the abbreviation ECL is, Options are ⇒ (A) Emitter Coupled Logic, (B) Electron Carrier Logic, (C) Encoding Clock Logic, (D) Electrostatic Channel Logic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The logic represented by the abbreviation ECL is
A.	Emitter Coupled Logic [Correct Answer]
B.	Electron Carrier Logic [Wrong Answer]
C.	Encoding Clock Logic [Wrong Answer]
D.	Electrostatic Channel Logic [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a shunt-shunt negative feedback amplifier, as compared to the basic amplifier
both input and output impedances, decrease
input impedance decreases but output impedance increase
I/P impedance increases but O/P impedance decreases
both input and O/P impedance increases

⇒ Consider the following statements:

Internal sorting is used if the number of items to be sorted is very large.
External sorting is used if the number of items to be sorted is vary large.
External sorting needs auxiliary storage.
Internal sorting needs auxiliary storage.

Which of the above statements are correct?
1 and 2
2 and 3
3 and 4
2 and 4

⇒ In a four variable K map eight adjacent cells give
single variable term
two variable term
three variable term
four variable term

⇒ Highest value of Autocorrelation of a function 100 cos 50 pt is
50
100
zero
100/p

⇒ For operation of enhancement only N-channel MOSFET, value of gate voltage has to be
zero
low positive
high negative
high positive

⇒ Which of the following is not a keyword in C?
int
float
return
capital

⇒ The I/P impedance of a short circuited quarter wave long transmission line is
purely reactive
purely resistive
depend on the characteristic impedance of the line
none of the above

⇒ An amplifier with resistive -ve feedback has two left poles in its open loop transfer function. The amplifier
will always be unstable at high frequencies
will be stable for all frequencies
may be unstable, depending on the feedback factor
will oscillate at low frequencies

⇒ The log magnitude plot of the given figure is
type 0 system
type 1 system
type 2 system
either type 0 or type 1 system

⇒ A radar beacon is a small radar set having a receiver, a separate transmitter and an antenna.
TRUE
FALSE

⇒ A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at t =
zero
infinity
L/R
R/L

⇒ A cavity resonator is
a hollow metallic enclosure
a hollow enclosure having magnetic material as its walls
a hollow enclosure having dielectric material as its walls
either (b) or (c)

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then carrier frequency is
0.159 MHz
1.59 MHz
15.9 MHz
159 MHz

⇒ In E plane metal plate lens antenna
travelling wavefronts are retarded
travelling wavefront are accelerated
travelling wavefront remains unaffected
none of the above

⇒ The counter shown in the given figure is built using 4 -ve edge triggered toggle FFs. The FF can be set asynchronously when R = 0. The combinational logic required to realize a modulo-13 counte
F = Q₄ Q₃ Q₂ Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄Q₃Q₂Q₁

⇒ Common base configuration is little used because
it has low input impedance
it has high input impedance
it does not heat up
it has very high gain

⇒ Initially the number decimal 8 is stored. If instruction RAL is executed twice, the final number stored will be
decimals 8
decimal 16
decimal 32
decimal 2

⇒ In integral cycle control the period of on-off control should be more than mechanical time constant of load.
TRUE
FALSE

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88W
7.3 W
73 W

⇒ A single phase half bridge inverter required to feed R-L loads needs
2 thyristors
4 thyristors
2 thyristors and two diodes
4 thyristors and 4 diodes

⇒

Assertion (A): Tunnel diode is used in many pulse and digital circuits.

Reason (R): The v-i curve of a tunnel diode resembles letter 'N'.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statements about PCM

PCM is not noise resistant
PCM requires complex encoding and quantizing circuitry
PCM requires large bandwidth

Which of the above are correct?
1 only
1, 2, 3
2, 3
1 and 3

⇒ In figure, transistor β_dc = 100 and LED voltage when it is conducting is 2 V. Then the base current which saturates the transisto
18 mA
1.8 mA
0.18 mA
0.018 mA

⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper

⇒ In a degenerate n type semiconductor material, the Fermi level,
is in valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near valence band

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒ n-type semiconductors
are negatively charged
are produced when indium is added as impurity to germanium
are produced when phosphorus is added as impurity to silicon
none of the above

⇒ Karnaugh map is used to
minimise the number of flip flops in a digital circuit
minimise the number of gates only in a digital circuit
minimise the number of gates and fan in a digital circuit
design gates

⇒ In a CE bipolar transistor operating in active region, collector current is independent of
V_CE
I_B
both V_CE and I_B
none of the above

⇒

Assertion (A): Oxide coated cathodes are very commonly used.

Reason (R): Work function of oxide coated cathode is 1 eV whereas it is 4.5 eV for pure tungsten.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true