Question is ⇒ The logic performed by the high-noise immunity logic circuit shown belo, Options are ⇒ (A) OR, (B) AND, (C) NOR, (D) NAND, (E) , Leave your comments or Download question paper.

Question is ⇒ The logic performed by the high-noise immunity logic circuit shown belo, Options are ⇒ (A) OR, (B) AND, (C) NOR, (D) NAND, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The logic performed by the high-noise immunity logic circuit shown belo
A.	OR [Wrong Answer]
B.	AND [Wrong Answer]
C.	NOR [Wrong Answer]
D.	NAND [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that
a double pole is present
a pair of complex conjugate poles is present
either (a) or (b)
neither (a) nor (b)

⇒ Which of the following is not valid in case of bipolars?
It has a low input impedance
It has high voltage gain
It is a current controlled device
It is difficult to bias

⇒ Which of these instruments has highest power consumption?
Dynamometer
Electrostatic
Moving coil
Hot wire

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ If 4 quadrant operation is required we need
dual converter
full converter
semi converter
none of the above

⇒ Which of the following semi-conductor has forbidden energy gap less 1 eV?
Sulphur
Phosphorous
Germanium
Carbon

⇒ For air filled circular waveguides
the attenuation due to imperfect conducting walls is negligible
the attenuation due to imperfect dielectric is negligible
both the attenuation i.e. due to imperfect conducting walls and due to imperfect dielectric are significant
the total attenuation is almost zero

⇒ The capacitor filter provides poor voltage regulation because
the increase in ripple with load current causes a decrease in average voltage
the increase in ripple with load current causes a increase in average voltage
filter promotes ripple at peak voltage
none of the above

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒ Power gain of an antenna in a given direction is the ratio of
average power to maximum power
radiation intensity in that direction to the total input radiated power
radiation intensity in that direction to the average radiated power
none of the above

⇒ The dimensions of EMF are
ML²I^-1T^-3
M^-1T^-3
ML²I^-2T^-3
ML³I^-1T^-3

⇒ The percentage saving in power when the carrier and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% will be nearly
0.5
0.66
0.75
0.83

⇒ Assuming a minimum angle of elevation of 5°, a geosynchronous satellite remains in line-of-sight for __________ percentage of Earth's surface.
30.3
42.4
50
25

⇒ For any given two port network, any parameter set can be determined from measurements made at the two ports.
TRUE
FALSE

⇒ The circuit of figur
positive clipper
negative clipper
combination clipper
either (a) or (b)

⇒

Match the following:

	List I (Modes)		List II (Characteristic)
A.	Evanescent	1.	Rectangular waveguide does not support
B.	Dominant mode	2.	No wave propagation
C.	TM₁₀ and TM₀₁	3.	Lowest cut-off frequency

A-1, B-2, C-3
A-2, B-3, C-1
A-1, B-3, C-2
A-2, B-1, C-3

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒ A microprocessor can understand instruction written in
machine language only
mnemonics operation codes only
high language only
both machine language and mnemonics operation codes

⇒ A dc machine has 6 poles all connected in series. Each pole has 9 H inductance and field current is 2 A. Total inductance and total energy stored are
9 H and 18 J
18 H and 36 J
54 H and 108 J
108 H and 216 J

⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of
10°C
25°C
50°C
75°C

⇒

Assertion (A): When cathode temperature is increased from 2500 K to 2550 K, thermionic emission current may increase by about 50%.

Reason (R): Thermionic emission current ∝ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of valence electrons in a donor atom is
2
3
4
5

⇒ Karnaugh map is used to
minimise the number of flip flops in a digital circuit
minimise the number of gates only in a digital circuit
minimise the number of gates and fan in a digital circuit
design gates

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ For an RC admittance function
the lowest critical frequency is a zero
the highest critical frequency is a pole
the lowest critical frequency is zero and the highest critical frequency is a pole
the lowest critical frequency is a pole

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ What is the purpose of a start in RS232 serial communication protocol?
To synchronise receiver for receiving every byte
To synchronise receiver for receiving a sequence of byte
Acts as a parity bit
To synchronise receiver for receiving the last byte

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes