Question is ⇒ The logic circuit given below converts a binary code y1 y2, y3, Options are ⇒ (A) Excess - 3 code, (B) Gray code, (C) BCD code, (D) Hamming, (E) , Leave your comments or Download question paper.

Question is ⇒ The logic circuit given below converts a binary code y1 y2, y3, Options are ⇒ (A) Excess - 3 code, (B) Gray code, (C) BCD code, (D) Hamming, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The logic circuit given below converts a binary code y₁ y₂, y₃
A.	Excess - 3 code [Wrong Answer]
B.	Gray code [Wrong Answer]
C.	BCD code [Correct Answer]
D.	Hamming [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ Consider the following DO statement in Fortran 77 1
10
3
4

⇒ Which material is generally used for LED?
Compounds of silica
Compounds of gallium
Compounds of phosphorus
Compounds of sulphur

⇒ As compared to their values in free space
velocity of electric wave in dielectric is smaller but wave length of electric wave is more
both velocity and wave length of electric wave in dielectric are higher
both velocity and wave length of electric wave in dielectric are smaller
wave length of electric wave is less but velocity is more in dielectric

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒ 50 independent low pass signals of bandwidth W, 2W, 3W, W, 2W, 3W, W, 2W, 3W Hz are to be time division multiplexer on a common channel using PAM. To achieve this, the minimum transmission capacity of the channel should be __________ .
1 Hz
12 Hz
3 Hz
6 Hz

⇒ n type semiconductors
are negatively charged
are produced when indium as impurity is added to germanium
are produced phosphorus as impurity is added to silicon
none of the above

⇒ For a series R-L-C circuit tuned at resonant frequency which of the following statements is correct?
The voltage across inductance is greater than applied voltage
The voltage across capacitance is greater than applied voltage
The voltage across both inductance and capacitance is greater than applied voltage
The voltage across both inductance and capacitance is less than applied voltage

⇒

Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If f=0
X_L = 0 and X_C = 0
X_L = ∞, X_C = ∞
X_L = 0 and X_C = ∞
X_L = ∞ and X_C = 0

⇒ Which camera tube has highest dark current?
Plumbicon
Vidicon
Saticon
GCD imager

⇒ Load cell uses
piezoelectric crystal
capacitor
mutual inductance
strain gauge

⇒ Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represe
unit circles
constant resistance circles
constant reactance circles
constant reflection coefficient circles

⇒ An RL admittance function can also be realized as
RC admittance function
RC impedance function
LC admittance function
LC impedance function

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒

Match the following:

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ The input and output signals for CE amplifier are always
equal
in phase
out of phase
complementary to each other

⇒ In a picture tube, the video signal is applied to
cathode
grid
any anode
either cathode or grid

⇒

Assertion (A): If an event A can happen in m ways and another event B can happen in n ways, both can happen in mn ways.

Reason (R): Two events are mutually exclusive if happening of either precludes the occurrence of other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): As per Miller theorem a capacitance C from input to output appears as a much larger capacitance across input terminals

Reason (R): In a lag network the output voltage appears across capacitor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ Which of the following is decimal equivalent of the binary 1111111?
27
87
127
167

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_B
24 μA
23 μA
20 μA
10 μA

⇒

Assertion (A): Gray code is used in shaft position encoding.

Reason (R): In gray code only a single bit change occurs when going from one code to another.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The dependent current source shown in given fig
delivers 80W
absorbs 80W
deliver 40W
absorbs 40W

⇒

Match the following:

	List I		List II
A.	Title bar	1.	Window menu
B.	Control menu box	2.	First row of window
C.	start-button	3.	box in title bar
D.	Control	4.	Button on mouse

A-3, B-2, C-4, D-1
A-2, B-3, C-4, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ In a TV, the output from RF tuner is about
1 μV
1000 μV
100 μV
0.5 μV

⇒ In a 4-ary FSK, the frequencies are separated by f_s. Then they are
in phase
in phase opposition
orthogonal
none of the above