Question is ⇒ The log magnitude for the system in the given figure is (where T =, Options are ⇒ (A) 20 log (1 + ωT), (B) -20 log (1 + ωT), (C) -10 log (1 + ω2T2), (D) -20 log (1 + ω2T2), (E) , Leave your comments or Download question paper.

Question is ⇒ The log magnitude for the system in the given figure is (where T =, Options are ⇒ (A) 20 log (1 + ωT), (B) -20 log (1 + ωT), (C) -10 log (1 + ω2T2), (D) -20 log (1 + ω2T2), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The log magnitude for the system in the given figure is (where T =
A.	20 log (1 + ωT) [Wrong Answer]
B.	-20 log (1 + ωT) [Wrong Answer]
C.	-10 log (1 + ω²T²) [Correct Answer]
D.	-20 log (1 + ω²T²) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A dynamic RAM chip has much smaller cell than a static RAM chip.

Reason (R): In dynamic RAM one bit of information is stored as the charge on a capacitor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following DO statement in Fortran 77 1
10
3
4

⇒ If r_e is ac resistance of diode, the Thevenin input impedance of a differential amplifier is
r_e
br_e
2 br_e
0.5 br_e

⇒ For a Mod-64 synchronous counter the number of flip flops and AND gates needed is
6 and 4 respectively
4 and 6 respectively
7 and 5 respectively
5 and 7 respectively

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ The basic shift register operations are
serial in - serial out
serial in - parallel out
parallel in - serial out
all of the above

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒ Electric lines of force do not cross each other because
the lines of force mutually repel each other
the lines of force emanate from a point charge
the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible
none of the above

⇒ In a turnstile antenna the crossed dipoles are excited with voltages
in phase with each other
90° out of phase with each other
120° out of phase with each other
180° out of phase with each other

⇒ The image frequency of a superheterodyne receiver is
independent of the frequency at which the receiver is tuned
always outside the operating range of the receiver
typical to FM receivers only
not rejected by the IF tuned circuits

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ The temperature coefficient of resistance for a thermistor is
low and negative
low and positive
high and negative
high and positive

⇒ A TV receiver has 20 kV EHT supply and total beam current (for 3 electron guns) of 1500 μA. The power handled by IHVT is
3 W
30 W
300 W
0.3 W

⇒ In a Vidicon camera tube,
both sides of the target plate have the coating of tin oxide
both sides of the target plate have the coating of antimony tri-sulphide
the side of target plate facing the light has a coating of tin oxide and the side facing electron gun has a coating of antimony trisulphide
the side of target plate facing the light has a coating of antimony trisulphide while the side facing the electron gun has a coating of tin oxide

⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs

⇒ The input to negative clamper has a peak value of V_p. Then in the output the positive and negative peaks are nearly
0 and -2 V respectively
V_p and -V_p respectively
2 V_p and 0 respectively
none of the above

⇒

Assertion (A): Nyquist stability criterion uses the number of encirclements around (-1 + j0) point in GH plane to determine stability

Reason (R): The (-1 + j0) point in the s plane lies in the Nyquist path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A permanent magnet moving coil meter can be used as
ac only
dc only
both ac and dc
low frequency ac and dc

⇒

Assertion (A): Magnetic susceptibility of diamagnetic materials is much less than that of paramagnetic materials.

Reason (R): For diamagnetic as well as paramagnetic materials, μ_r is nearly equal to 1.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ The conduction band is
same as forbidden energy gap
generally located on the top of the crystal
generally located on the bottom of the crystal
a range of energies corresponding to the energies of the free electrons

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ If a common emitter amplifier with an emitter resistance R_C has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
50 kΩ
0.98 kΩ
50 Ω
0.98 Ω

⇒ When a power diode is conducting, the voltage drop across it is about
I V
5 V
20 V
50 V

⇒ Negative feedback lowers the cut off frequency and increase the upper cut off frequency of amplifier.
TRUE
FALSE

⇒ In an FM signal, the modulating frequency is 2 kHz and maximum deviation is 10 kHz. The bandwidth requirement is
2 kHz
10 kHz
5 kHz
32 kHz

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ In figure, the total power consume
10 W
12 W
16 W
20 W

⇒ In a line VSWR of a load is 6 dB. The reflection coefficient will be
0.033
0.33
0.66
3.3

⇒ A thyristor is reverse biased. A positive gate pulse is applied. The thyristor
will be turned on
may or may not turn on
will not turn on
will turn on after sometime