Question is ⇒ The knee voltages in silicon and germanium diodes respectively are, Options are ⇒ (A) 0.3 V and 0.7 V, (B) 0.7 V and 0.3 V, (C) 0.7 V each, (D) 0.3 V each, (E) , Leave your comments or Download question paper.

Question is ⇒ The knee voltages in silicon and germanium diodes respectively are, Options are ⇒ (A) 0.3 V and 0.7 V, (B) 0.7 V and 0.3 V, (C) 0.7 V each, (D) 0.3 V each, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The knee voltages in silicon and germanium diodes respectively are
A.	0.3 V and 0.7 V [Wrong Answer]
B.	0.7 V and 0.3 V [Correct Answer]
C.	0.7 V each [Wrong Answer]
D.	0.3 V each [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Ferrites are
ferromagnetic materials
ferrimagnetic materials
ferroelectric materials
ferri-ferromagnetic materials

⇒ Which of the following circuit would be preferred for a 355 KHz IF amplifier?
Resistance loaded
Double tuned transformer
Video amplifier
Class C

⇒ The tape recorders used in homes have
common head and common amplifier system for recording and playback
different heads and amplifiers for recording and playback
same head but different amplifiers for recording and playback
different heads but same amplifier for recording and playback

⇒ The polynomial P (s) = (s - 1) (s² + 1) (s + 2) (s + 3) is
Hurwitz but not strictly Hurwitz
not Hurwitz
strictly Hurwitz
anti/Hurwitz

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is
1 kHz
7.5 kHz
75 kHz
100 MHz

⇒ What is the direction of control bus?
Unidirection into μp
Unidirection out of up
Bidirectional
Mixed direction i.e., some lines into μp and some other out of μp

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ BCD number 1100111 = __________ ₁₀
66
67
68
69

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒ For very low frequencies, v₀/v_i in the given figure eq
1
0
∞
0.5

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ Commercial Frequency deviation of FM is
70 kHz
75 kHz
80 kHz
65 kHz

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)

⇒ For measurement of surface temperature of solids the elements of RTD is usually in the shape of
bar
coil
flat grid
either (a) or (b)

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 0.76
0.3, 0.95

⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed

⇒ In figure, D₂ turns on
v_i is more positive than V₁
v_i is less positive than V₁
v_i is more negative than V₂
v_i is less negative than V₂

⇒ A 16 bit counter type ADC uses 1 MHz clock then its maximum conversion time is __________ .
16 μs
15 ms
6.6 ms
66 ms

⇒ A constant k high pass filter has f_c = 3000 Hz. At f = 1000 Hz, the phase shift is
zero
p
2 p
more than p

⇒ If B_max is the maximum flux density, eddy current loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ Low gain-bandwidth product of a JFET is due to
reduced number of holes
junction capacitive effects
low degree of isolation between input and output
all of the above

⇒ If an electron move through a potential difference of 500 V, the energy possesses by it will be
500 ergs
500 joules
500 eV
500 mV

⇒ In the integer expression - A * B div C + D which operation is done first in Pascal
-
*
div
+

⇒ In which of the following does a negative resistance region exist in the v-i characteristics?
PIN diode
Schottky diode
Tunnel diode
Zener diode

⇒

Assertion (A): For a physically realisable driving point function, the degree of numerator and denominator should be equal.

Reason (R): The sum of positive real functions is real.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a practical current source, the load current
is always equal to source current
is always less than source current
is always equal to or less than source current
cannot be higher than source current

⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only

⇒ The decimal equivalent of the hexadecimal number (3 E 8)₁₆ is
1000
982
768
323