Question is ⇒ The Kirchoff's laws fail in which of the following circuits?, Options are ⇒ (A) Linear circuits, (B) Non-linear circuits, (C) Lumped parameters circuits, (D) Distributed parameters circuits, (E) , Leave your comments or Download question paper.

Question is ⇒ The Kirchoff's laws fail in which of the following circuits?, Options are ⇒ (A) Linear circuits, (B) Non-linear circuits, (C) Lumped parameters circuits, (D) Distributed parameters circuits, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The Kirchoff's laws fail in which of the following circuits?
A.	Linear circuits [Wrong Answer]
B.	Non-linear circuits [Wrong Answer]
C.	Lumped parameters circuits [Wrong Answer]
D.	Distributed parameters circuits [Correct Answer]
View Answer 8 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When atoms are held together by the sharing of valence electrons
each atom becomes free to move
neutrons start shifting
they form a covalent bond
some of the electrons are lost

⇒ We can know the arrangement of atom in a material by studying electron diffraction pattern.
TRUE
FALSE

⇒ Two thyristor of same rating and same specifications
will have equal turn on and turn off periods
will have equal turn on but unequal turn off periods
may have equal or unequal turn on and turn off periods
will have unequal turn on and turn off periods

⇒

Assertion (A): Stubs, directional couplers and baluns are very commonly used in communication systems

Reason (R): Characteristic impedance of a line is an important parameter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ Which type of modulator amplifier is used in AM transmitter?
Class A
Class B
Classes AB
Class C with negative feedback

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒ A PC can be upgraded to a multimedia PC by adding CD ROM drive, sound card etc.
TRUE
FALSE

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ For type 1 system the velocity lag error is
inversely proportional to bandwidth of system
directly proportional to gain constant
inversely proportional to gain constant
independent of gain constant

⇒ In 8085
all operations are on 8 bit data
majority of operations are on 8 bit data
all operations are on 8 bit or 4 bit data
either (a) or (c)

⇒ The pre-emphasis circuit is used
prior to modulation
after demodulation
for low frequency components of the signal
none of the above

⇒

Assertion (A): A dc stabilizer has constant output voltage irrespective of variations in input voltage and load current

Reason (R): A dc series regulator uses a zener diode across the load to stabilize the output voltage.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An exponential amplifier has diode in feedback path.
TRUE
FALSE

⇒ In a photodiode the current is due to
majority carriers
minority carriers
both majority and minority carriers
either (a) or (b)

⇒ Entropy gives
measure of Uncertainty
rate of Information
average information
probability of Information

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒ Which of the following is not treated as hexadecimal constant by assembler in 8085?
64 H
5 AFH
AFH
OCFH

⇒ In an integral controller
the output is proportional to input
the rate of change of output is proportional to input
the output is proportional to rate of change of input
none of the above

⇒ Companding is used
to overcome quantising noise in PCM
in PWM receivers to reduce impulse noise
to protect small signals in PCM from quantising noise
none of the above

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒

Assertion (A): The expression E = - ΔV, where E is the electric field and V is the potential is not valid for time varying fields.

Reason (R): The curl of a gradient is identically zero.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ When satellite radio beam is aimed towards earth, it illuminates on the earth for an oval shaped area called
foot print
beam area
satellite service area
radiated area

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ For a = - 1, find the value of V_{2∞
0
V₁
none of the above}

⇒ In phase modulation, the phase deviation is
proportional to the amplitude of the signal and varies with frequency
remains constant while amplitude and frequency of signal varies
proportional to the amplitude of the signal and independent of the frequency
none of the above