Question is ⇒ The <i>Z</i> transform of a particular signal is given, Options are ⇒ (A) non causal and stable, (B) causal and stable, (C) unstable and noncausal, (D) can't say, (E) , Leave your comments or Download question paper.

Question is ⇒ The <i>Z</i> transform of a particular signal is given, Options are ⇒ (A) non causal and stable, (B) causal and stable, (C) unstable and noncausal, (D) can't say, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The Z transform of a particular signal is given
A.	non causal and stable [Wrong Answer]
B.	causal and stable [Correct Answer]
C.	unstable and noncausal [Wrong Answer]
D.	can't say [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The hybrid p model of a transistor can be reduced to h parameter model and vice versa.

Reason (R): Hybrid p and h parameter models are interrelated as both of them describe the same device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Bandwidth of an antenna is related with where Q is quality factor
Q ∝ B
Q ∝ 1/B
Q ∝ B²
Q ∝ 1/B²

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ Gold is often diffused into silicon P-N junction devices to
increase recombination rate
reduce recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ With on-chip decoding, n address lines can access
2n memory locations
2n² memory locations
2ⁿ memory locations
n² memory location

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒

Assertion (A): Superposition theorem can be used to find the output of a full wave rectifier excited by sinusoidal signal sources of different frequencies connected in series.

Reason (R): Superposition theorem is valid for all linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ For an N-point FFT algorithm with N = 2^m which one of the following statements is TRUE?
It is not possible to construct a signal flow graph with both input and output in normal order
The number of butterflies in the m^th stage is N/m
In-place computation requires storage of only 2N node data
Computation of a butterfly requires only one complex multiplication

⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
RST 5.5
RST 7.5
TRAP
INTR

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ With four Boolean variables, how many Boolean expressions can be performed?
16
256
1024 (1 K)
64K (64 x 1024)

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar

⇒ FIR digital filter having __________ stability than FIR filter.
good stability
poor stability
stability not guarnteed
poor stability

⇒

Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is
20 dB more
20 dB less
700 dB more
100 dB less

⇒ The drain characteristics of JFET are drawn between
V_GS and V_DS for different values of drain current
drain current and V_GS for different values of V_DS
drain current and V_DS for different values of V_GS
drain current and V_GSfor one value of V_DS

⇒ Which of the following is invariably found in SSB?
Tuned modulator
Class B, RF amplifier
Class C, audio amplifier
All of the above

⇒ In microwave system, waveguide twists
change the plane of polarization of a propagating wave
change the direction of a propagating wave
change the mode of a propagating wave
both (b) and (c)

⇒ TTL XOR gate is very suitable as LCO driver.
TRUE
FALSE

⇒ In a CE amplifier the ac cut off voltage is 9 V and slope of ac load line is - 0.5 mA/V. The ac saturation current is
9 mA
4.5 mA
3 mA
18 mA

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ A static induction thyristor
is a majority carrier device
is a minority carrier device
either a majority carrier or minority carrier device
has a total number of 2 leads

⇒ In a metal, the valence electrons
are not shared
are shared only between neighbouring atoms
are shared by all atoms
either (b) or (c)

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
31 v
32 v
insufficient data
none of these

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ When a current source I is suddenly connected across a two terminal relaxed RC circuit at time t = 0, the voltage across the current source is shown in figure. The RC circui
a series combination of R and C
a parallel combination of R and C
a series combination of R and parallel combination of R and C
a pure capacitor