Question is ⇒ The inverse Laplace transform of 1/(s - a)2 is, Options are ⇒ (A) eat, (B) t eat, (C) t2 eat, (D) eat/t, (E) , Leave your comments or Download question paper.

Question is ⇒ The inverse Laplace transform of 1/(s - a)2 is, Options are ⇒ (A) eat, (B) t eat, (C) t2 eat, (D) eat/t, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The inverse Laplace transform of 1/(s - a)² is
A.	e^at [Wrong Answer]
B.	t e^at [Correct Answer]
C.	t² e^at [Wrong Answer]
D.	e^at/t [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ The number of logic devices required in a Mod-16 synchronous counter are
4
5
6
7

⇒ Which of the following are applications of position control systems?
Control of sheet and metal thickness in hot rolling mill
Missile guidance of ships
Radar tracking system
All of the above

⇒ For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give
A + (B + C) D
A + BC + D
A(BC + D)
none of these

⇒ In a RAM chip with a total of 8096 words, the word addresses range from
1 to 8096
0 to 8095
1 to 8095
0 to 8096

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ For transistor 2 N 338 the manufacturer specifies P_max = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
10° C/W
100° C/W
1000° C/W
5000° C/W

⇒ 50 independent low pass signals of bandwidth W, 2W, 3W, W, 2W, 3W, W, 2W, 3W Hz are to be time division multiplexer on a common channel using PAM. To achieve this, the minimum transmission capacity of the channel should be __________ .
1 Hz
12 Hz
3 Hz
6 Hz

⇒ Consider the following statements about polar plots

Addition of a non-zero pole to a transfer function results in further rotation of polar plot through an angle of - 90° as ω → ∞
Addition of a pole at the origin to a transfer function rotates the polar plot at zero and infinite frequencies by a further angle of - 90°

Of the above statements:
Both are correct
Both are wrong
1 is correct and 2 is wrong
2 is correct and 1 is wrong

⇒ Noise limiter is provided on AM receivers to
reduce interfering noise due to ignition system
reduce noise due to electrical storms
reduce interference due to electrical machinery
all of the above

⇒ Power is drawn from a source at power factor 0.7. P_av = 300 watt. The reactive power is
0
105
100 VA
107 VA

⇒ The storage battery used in power stations and substations is generally
nickel cadmium battery
lead acid battery
zinc carbon battery
zinc carbon or lead acid battery

⇒ A two branch parallel tuned circuit has 100 Ω resistance and 0.1 H inductance in one branch and 10^-6 F capacitor in the other. At resonance frequency, the dynamic resistance is
10 Ω
100 Ω
1000 Ω
10000 Ω

⇒ 24 telephone channels, each band limited to 3.4 kHz are to be time division multiplexed using PCM. If sampling frequency is 10 kHz and number of quantization levels is 128, the required bandwidth of PCM is
1.68 MHz
240 kHz
81.6 kHz
3.072 MHz

⇒ An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is
0.1 V/mm
0.5 V/mm
1 V/mm
5 V/mm

⇒ Consider the following statements

Impedance of Gunn diode is about tens of ohms.
Impedance of Impatt diode is a few ohms.
Impedance of Impatt diode are of the same order.
Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?
all
1 and 2 only
1, 2 and 3
1, 2 and 4

⇒

Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Network transients are due to
circuit resistance
circuit voltage
changes in energy stored in L and C
circuit admittance

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ In paramagnetic materials
permanent magnetic dipoles exist but the interaction between neighbouring dipoles is negligible
permanent magnetic dipole do not exist
permanent magnetic dipoles exist and the interaction between neighbouring dipoles is very strong
permanent magnetic dipole moment may or may not exist

⇒ With 2's complement representation, the range of values that can be represented on the data bus of an 8 bit microprocessor is given by
-128 to 127
-128 to +128
-127 to 128
-256 to 256

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
current, voltage
current, current
voltage, current
voltage, voltage

⇒ For satellite communication, the frequency should be
equal to the critical frequency
more than the critical frequency
less than the critical frequency
none of these

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒ An inductance having X_L = 5 Ω and a capacitance having X_C = 5 Ω are connected in parallel across 100 V, 50 Hz supply. The current drawn from source is
zero
20 A
40 A
28.28 A

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves