Question is ⇒ The intrinsic resistivity of silicon at 300 K is about, Options are ⇒ (A) 1 Ω-cm, (B) 400 Ω-cm, (C) 10000 Ω-cm, (D) 230000 Ω-cm, (E) , Leave your comments or Download question paper.

Question is ⇒ The intrinsic resistivity of silicon at 300 K is about, Options are ⇒ (A) 1 Ω-cm, (B) 400 Ω-cm, (C) 10000 Ω-cm, (D) 230000 Ω-cm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The intrinsic resistivity of silicon at 300 K is about
A.	1 Ω-cm [Wrong Answer]
B.	400 Ω-cm [Wrong Answer]
C.	10000 Ω-cm [Wrong Answer]
D.	230000 Ω-cm [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ The most commonly used bias in BJT amplifier circuits is
voltage divider bias
emitter bias
collector bias
collector feedback bias

⇒ The trigonometric Fourier series for the waveform f(t) shown below con
only cosine terms and zero value for the dc component
only cosine terms and a positive value for the dc component
only cosine terms and a negative value for the dc component
only sine terms and a negative for the dc component

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ If a RAM has 34 bits in its MAR and 16 bits its MAR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ If average correlation between v₁(t) and v₂(t) is R₁₂(t) and average correlation between v₂(t) and v₁(t) is R₂₁(t) then
R₁₂(t) = R₂₁(t)
R₂₁(t) = R₁₂(t)
R₁₂(t) = - R₂₁(t)
none of these

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ In a semi converter feeding a resistive load,
the waveshapes of input voltage and input current are always similar
the waveshapes of input voltage and input current can never be similar
the waveshapes of input voltage and input current are similar only if firing angle is zero
the waveshapes of input voltage and input current are similar only if firing angle is high

⇒ If too large current passes through the diode
all electrons will leave
all holes will freeze
excessive heat may damage the diode
diode will emit light

⇒ The modulating frequency in frequency modulation is increased from 10 kHz to 30 kHz. The bandwidth is increased by
6
1/6 times
increase by 30 kHz
increase by 20 kHz

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒ Gain stability in an oscillator can bs achieved by
providing negative feedback
providing positive feedback
using low Q circuits
controlling the gain

⇒ Six sets of electromagnetic waves are given bel
VLF, LF, MF, HF, VHF, UHF
LF, VLF, MF, HF, VHF, VHF
LF, VLF, HF, MF, VHF, UHF
VHF, VLF, HF, MF, LF, UHF

⇒ In using mesh current method it is necessary that at least one mesh current links every element.
TRUE
FALSE

⇒ Microwave signals follow the curvature of the earth and the phenomenon is known as
tropospheric scatter
duct propagation
Faraday effect
none of the above

⇒ In 180° mode of operation of a 3 phase bridge inverter, two thyristors conduct at one time.
TRUE
FALSE

⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
forward characteristics of thyristors
reverse recovery characteristics of thyristors
both forward and reverse recovery characteristics of thyristors
none of the above

⇒ For the system in the given figure, the transfer function C(s)/R(s
G₁ + G₂ + G₃
G₁ G₂ + G₃
G₁ G₂ G₃
(G₁ + G₂) G₃

⇒ When a bit is 0 is a DDR, it makes the corresponding port pin an __________ On the other hand, a 1 bit programs a __________ Pin.
output, input
output, output
input, input
input, output

⇒ The causal system given below is _______
minimum phase
maximum phase
mixed phase
none of these

⇒ A 2-terminal network consists of one of the RLC elements. The elements is connected to an ac supply. The current through the element is 1 A. When an inductor is inserted in series between the source and the element, the current through the element becomes 2 A. What is this element?
A resistor
An inductor
A capacitor
Cannot be single element

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ All of the following elements have three valence electrons EXCEPT
boron
indium
gallium
arsenic

⇒ A cycloconverter uses
natural commutation
forced commutation
either natural or forced commutation
both natural and forced commutation together

⇒ 1011₂ x 101₂ = __________ ₁₀
55
45
35
25

⇒ Which of the following closely represents the resistance-temperature characteristics of thermistor?
R_T = a R₀ e^b/t
R_T = a R₀ E^-b/t
R_T = - a R₀ e^-b/t
R_T = - R₀ e^b/t

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping