Question is ⇒ The interface chip for 8086 and 16 bit ADC is, Options are ⇒ (A) 8259, (B) 8255, (C) 8253, (D) 8251, (E) , Leave your comments or Download question paper.

Question is ⇒ The interface chip for 8086 and 16 bit ADC is, Options are ⇒ (A) 8259, (B) 8255, (C) 8253, (D) 8251, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The interface chip for 8086 and 16 bit ADC is
A.	8259 [Wrong Answer]
B.	8255 [Correct Answer]
C.	8253 [Wrong Answer]
D.	8251 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
4.77 kHz
47.7 kHz
477 kHz
4770 kHz

⇒ Access time of a storage is the time required
to write one word into the memory
to read one word from the memory
to write one word into and to read one word from the memory
either to write one word or to read one word

⇒ Multiple member of antennas are arranged in arrays in order to enhance what property?
Both directivity and bandwidth
Only directivity
Only bandwidth
Neither directivity nor bandwidth

⇒ Which statement is false as regards holes
Holes exist in conductors as well as semiconductors
Holes constitute positive charges
Holes exist only in semiconductors
Holes and electrons recombine

⇒ Acoustic strain gauges
have good linearity of measurement
do not have long term stability
have a large range of measurement
have an accuracy range of 0.1-1% depending on environment

⇒ The ASCII code is for information interchange by a binary code for
alphabet only
number only
alpha-numeric and other common symbols
none of these

⇒ A UPS contains
rectifier
inverter
either rectifier or inverter
both rectifier and inverter

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒ The numerical value of directive gain may lie between
1 and + 1
0 and 1
0 and ∞
1 and ∞

⇒ In an SCR, the anode current is controlled by
gate current only
external circuit only
both gate current and external circuit
none of the above

⇒

Assertion (A): A binary number is a string of zeros and ones only

Reason (R): The base in a binary system is 2

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The multiplication time for 10-bit numbers with 1 MHz clock will be
32 μ sec
20 μ sec
21 μ sec
22 μ sec

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒

Assertion (A): Typical value of thermal resistance from source to sink of an SCR is about 0.3° C/W

Reason (R): Heat sinks of thyristors are generally made of aluminium.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after XRA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ Some possible functions of AGC in a TV receiver are

To increase gain for weak signals
To decrease gain for strong signals
To change the contrast when we switch from one channel to other
To reduce flutter

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2, 3
2, 3, 4

⇒ The gain of an FET amplifier can be changed by changing
r_m
g_m
R_d
none of the above

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ A single phase energy meter operates on induction principle.
TRUE
FALSE

⇒ Which of following is recursive system?
y(n - 1)
y(n + 1)
y(n)
y(n) + y(n + 1)

⇒ An electromagnetic wave is incident normally on a dielectric boundary. It is
totally reflected
partially reflected and partially refracted
totally absorbed
none of the above

⇒ The first critical frequency nearest the origin of the complex frequency plane for an RL driving point impedance will be
a zero in left half plane
a zero in right half plane
a pole in left half plane
a pole or zero in left half plane