Question is ⇒ The inputs to a 3 bit binary adder are 1112 and 1102. The output will be, Options are ⇒ (A) 101, (B) 1101, (C) 1111, (D) 1110, (E) , Leave your comments or Download question paper.

Question is ⇒ The inputs to a 3 bit binary adder are 1112 and 1102. The output will be, Options are ⇒ (A) 101, (B) 1101, (C) 1111, (D) 1110, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The inputs to a 3 bit binary adder are 111₂ and 110₂. The output will be
A.	101 [Wrong Answer]
B.	1101 [Correct Answer]
C.	1111 [Wrong Answer]
D.	1110 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ For H(s) to be positive real, the condition Re[H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞ is
a necessary condition
a sufficient condition
a necessary and sufficient condition
is not a necessary condition

⇒ Which of the following is not necessarily the advantage of SSB over double sideband, full carrier AM?
The signal is more noise resistant
More channel space is available
Transmitter circuits must be more stable, given better reception
Considerably less power is required for the same signal strength

⇒ To bypass a 100 ohm emitter resistor at
10 μF
100 μF
1000 μF
1 μF

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ Consider the follo
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ F = ∑(0, 3, 4, 5, 7) =
[B ⊕ C] + AC
B'C' + BC + AC
AB + BC + CA
None

⇒ A class A chopper has an input voltage of 200 V. T_on = 1.5 ms and T_off = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are
0.5, 100 V and 1
0.25, 50 V and 3
0.25, 50 V and 1
0.5, 100 V and 3

⇒ The maximum power output of a standard A earth station over the total band allocated to satellite communication is about
0.5 kW
8 kW
20 kW
50 kW

⇒ Tropospheric scatter is used with frequencies in the range of
VLF
HF
UHF
VHF

⇒

Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.

Reason (R): Operator 'a' has a value 1 ∠ 120°.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ In a purely inductive ac circuit, the supply voltage and voltage induced across inductance are equal and opposite at all instants.
TRUE
FALSE

⇒ Time delay produced by an instruction code given below using 2 MHz clock
1783 μs
1787 μs
1781 μs
1797 μs

⇒ Which of the following pairs of octal and binary numbers are not equal?
111 11011₂ = 767₈
110110101₂ = 665₈
11010₂ = 3₈
10101.11₂ = 25.6₈

⇒ For the circuit in figure, fed by a unit step voltage, v_{c1 - e^-t/RC
e^-t/RC
e^t/RC
1}

⇒ Which control action is also called rate control?
Proportional
Derivative
Integral
Proportional plus integral

⇒ The essential condition for antenna array to be linear is that
individual antennas of the array must be of equal size
individual antennas of the array must be equally spaced along a straight line
any two individual antennas of the array must not be in the same direction
none of the above

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}

⇒ For the truth table of the given figure
A + B + C
A + BC
A
B

⇒ In N-type semiconductor
electrons are majority carriers while holes are minority carriers
electrons are majority carriers while holes are majority carriers
both electrons as well as holes are majority carriers
both electrons as well as holes are minority carriers

⇒

Assertion (A): In hot wire instrument the material of hot wire in generally platinum iridium.

Reason (R): A hot wire ammeter is suitable for ac only

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The number of leads in a power semiconductor diode are
2
3
4
2 or 3

⇒ In case of a low level AM transmitter, the amplifier modulated stage must be
class A
class B
class B (linear)
class C

⇒ The curve representing Ohm's law is
linear
a parabola
a hyperbola
sine function

⇒ A material has conductivity of 10⁵ mho/m and permeability of 4p x 10^-7 H/m. The skin depth at 9 GHz is
1.678 μm
26 μm
17 μm
32.32 μm

⇒ An electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis is
synchro control transformer
LVDT
stepper motor
tacho generator

⇒

Assertion (A): A backward wave oscillator has an internal positive feedback.

Reason (R): A positive feedback is necessary for sustained oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2