Question is ⇒ The input impedance of op-amp circuit of figur, Options are ⇒ (A) 120 k ohm, (B) 110 k ohm, (C) infinity, (D) 10 k ohm, (E) , Leave your comments or Download question paper.

Question is ⇒ The input impedance of op-amp circuit of figur, Options are ⇒ (A) 120 k ohm, (B) 110 k ohm, (C) infinity, (D) 10 k ohm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The input impedance of op-amp circuit of figur
A.	120 k ohm [Wrong Answer]
B.	110 k ohm [Wrong Answer]
C.	infinity [Wrong Answer]
D.	10 k ohm [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which is correct for a driving point function?
If the real part of a pole or zero is zero, that pole must be simple
If the real part of a pole or zero is zero, that pole or zero must be simple
If the real part of a zero is zero, that pole or zero must be simple
If the real part of a zero is zero that zero must be simple

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω

⇒ Which is the dominant mode in rectangular waveguides?
TE₁₀
TE₁₁
TE₀₁
TM₁₁

⇒ A CE amplifier has a high input signal. In the wave shape of emitter current
positive and negative half cycles will be symmetrical
positive half cycle will be elongated and negative half cycle will be compressed
positive half cycle will be compressed and negative half cycle will be elongated
the half cycles may be either elongated or compressed

⇒ In FORTRAN 77 the total number of characters in a variable can be a maximum of
6
1
8
9

⇒ Which of the following devices is used in the microprocessors?
JFET
BJT
MOSFET
CMOS

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ If V = 4 in the figure, the value of I_s is give
0.25
5/2 A
0
none

⇒ A capacitor having capacitance C is raised to voltage V. The energy stored will be
CV²
V²/C
0.5 V²C
0.5 C²V

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ In Pascal the repeat and while loops will terminate
only when the logical expression controlling the loop becomes true for both repeat and while loops
only when the logical expression controlling the loop becomes false for both repeat and while loops
only when the logical expression controlling the loop becomes true for repeat loop and false for while loop
only when the logical expression controlling the loop becomes false for repeat loop and true for while loop

⇒ Which of the following statement is false?
The zener diode is uses as a constant voltage source
The SCR is a silicon rectifier with a gate electrode to control when current flows from cathode to anode
The gate electrode in the FET corresponds to the collector in a bipolar transistor
None of the above

⇒ Digital circuits mostly use
Diodes
Bipolar transistors
Diodes and bipolar transistors
Bipolar transistors and FETs

⇒ The addition of n type impurity to intrinsic material creates allowable energy levels.
slightly below conduction band
slightly above conduction band
slightly below valence band
slightly above valence band

⇒ The leakage current in CB configuration may be around
few micro amperes
few hundred micro amperes
few milliamperes
few hundred milliamperes

⇒ The integral of a unit step function is
a unit impulse function
a unit pulse function
a ramp function of slope 1
none of the above

⇒ The function to Calculate the maximum value in the specified field of a database is
DM
DMAX
MAX
DBMAX

⇒ If the gate of JFET is reverse biased, the width of depletion region
becomes zero
is uniform
is more near the source
is more near the drain

⇒ The minimum step size required for a Delta modulator operating at 36 samples/sec to track the signal (here u(t) is the unit step function) x(t) = 125t (u(t) - u(t - 1)) + (250 - 125t) (u(t - 1) - u(t - 2)) So that slope overload is avoided, would be
2^-10
2^-8
2^-6
2^-4

⇒ A dielectric is subjected to alternating field. The dielectric losses are potential to
real part of dielectric constant
imaginary part of dielectric constant
both real and imaginary parts of dielectric constant
either real or imaginary part of dielectric constant

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ Which language has a preprocessor?
Fortran 77
Pascal
C
None of the above

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
E/R
E/LC
zero
infinity

⇒ Consider the following stateme
1, 4 are correct
1 and 2 correct
1, 2, 3 are correct
2, 3, 4 are correct

⇒ A 12 bit ADC is operating with 1 μs clock period. Total conversion time is 14 μs. ADC is
flash type
counting type
integrating type
successive approximation type

⇒ Assume that x = 5 and y = 2. Then in Java operation x + = y, the result is
x = 7
x = 2
x = 3
x = 2

⇒ Frequency shift keying is used mostly in
telegraphy
telephony
satellite communication
radio transmission

⇒ Which of the following factor does NOT contribute to the drift of a geostationary satellite from its stationary position in space?
Pressure of solar radiations
Gravitational changes due to Sun and Moon
Oblateness of the Earth
Weight of the satellite