Question is ⇒ The input gate current of FET is closer to, Options are ⇒ (A) few amperes, (B) few milli amperes, (C) few microamperes, (D) negligibly smaller value, (E) , Leave your comments or Download question paper.

Question is ⇒ The input gate current of FET is closer to, Options are ⇒ (A) few amperes, (B) few milli amperes, (C) few microamperes, (D) negligibly smaller value, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The input gate current of FET is closer to
A.	few amperes [Wrong Answer]
B.	few milli amperes [Wrong Answer]
C.	few microamperes [Wrong Answer]
D.	negligibly smaller value [Correct Answer]
View Answer 8 -9 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In which of the following logical group instructions of 8085 do the contents of accumulator remain unchanged?
ORA r
ORA M
ORI data
CMP r

⇒ Which junction transistor is preferred for high input and low output impedances?
Common emitter
Common base
Common collector
Any of the above

⇒ In a waveguide the dielectric region is generally
air
magnetic material
brass
mica

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ F.T. of continuous non-periodic signal is
aperiodic
periodic
a and b
none

⇒ X and Y are two random variables and Z = X + Y . Letmz, m_z, m_x, m_y represent mean of Z, X and Y. Then
m_z = m_x + m_y
m_z ≤ m_x + m_y
m_z< m_x + m_y
m_z > m_x + m_y

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10

⇒ In floating point representation decimal number 13.5 is
1101.1
1.1011 x 2³
0.11011 x 2⁴
11.011 x 2²

⇒

Match the following:

	List I (Theorems)		List II (Property of Network)
A.	Reciprocity	1.	Impedance matching
B.	Tellegen's	2.	Bilateral
C.	Superposition	3.	∑ V_jk I_jk = 0
D.	Maximum power transfer	4.	Linear
		5.	Non linear

A-1, B-2, C-3, D-4
A-1, B-2, C-3, D-5
A-2, B-3, C-4, D-1
A-2, B-3, C-5, D-1

⇒ In monolithic ICs, all the components are fabricated by
diffusion process
oxidation
evaporation
none

⇒ It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of
2
4
8
16

⇒ A 750 A circuit uses thyristor of current rating 175 A. If derating is 25%, the number of thyristors in parallel is
3
4
6
10

⇒ In high power radars, which of the following are used for switching?
Power diode
Power BJT
Power MOSFET
Thyristor

⇒ A voltage wave is v = 50 sin ωt. Its average value calculated over full one cycle is
zero
35.36 V
31.85 V
none of the above

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ The traffic-handling capacity of an Earth station on the uplink depends on
its EIRP
satellite antenna gain
noise associated with the satellite
all of the above

⇒ A telephone exchange has 9000 subscribers. If the number of calls originating at peak time is 10, 000 in one hour, the calling rate is
0.9
43017
0.81
0.1

⇒ For high frequencies a capacitor like
an open circuit
a short circuit
either open circuit or short circuit
none of the above

⇒ Which of the following are voltage controlled devices?
Vacum triode
FET
SCR
Both (a) and (b)

⇒

Assertion (A): Nyquist stability criterion uses the number of encirclements around (-1 + j0) point in GH plane to determine stability

Reason (R): The (-1 + j0) point in the s plane lies in the Nyquist path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider the network: Impedance of this network as a function of the complex frequency is consists of a certain number of zeros and poles. What is the location of po
-2
-2, ∞
2
2, ∞

⇒ Laplace transform of unit doublet is
1/s
s²
s
none

⇒ Rise time in a transistor is change from
10% of its final value to 90% of its final value
0% of its final value to 90% of its final value
10% of its final value to 100% of its final value
10% to its final value to 50% of its final value

⇒ Equipotential surfaces about a point charge are in which one of the following forms?
Sphere
Planes
Cylinders
Cubes

⇒ A twisted ring counter consisting of 4 FF will have
4 states
8 states
2⁴ states
None of the above

⇒ An R-L series circuit has R = 5 Ω and L = .01 H. It is fed by ac 50 Hz supply. The rms current in the circuit is 5 A. The active power supplied by the source is
25 W
50 W
125 W
250 W

⇒ In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time const
0.1 s
1 s
0.11 s
1.11 s

⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are
electronic only
electronic and ionic
electronic, ionic and permanent
electronic and permanent

⇒ Which of the following circuit cannot be used to demodulate SSB?
Phase discriminator
Produce detector
Balanced modulator
Beat frequency oscillator