Question is ⇒ The IF stage of a receiver employs, Options are ⇒ (A) capacitive coupling, (B) impedance coupling, (C) double-tuned transformer coupling, (D) single-tuned transformer coupling, (E) , Leave your comments or Download question paper.

Question is ⇒ The IF stage of a receiver employs, Options are ⇒ (A) capacitive coupling, (B) impedance coupling, (C) double-tuned transformer coupling, (D) single-tuned transformer coupling, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The IF stage of a receiver employs
A.	capacitive coupling [Wrong Answer]
B.	impedance coupling [Wrong Answer]
C.	double-tuned transformer coupling [Correct Answer]
D.	single-tuned transformer coupling [Wrong Answer]
View Answer 3 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A vertical loop antenna, like a horizontal dipole, is vertically polarised.
TRUE
FALSE

⇒ In the circuit of the given figure, V_{05 V
3.1 V
2.5 V
0}

⇒ In rectifier circuits, the rms value of ac component of output voltage is equal to
V_rms
0.5 V_rms
(V_rms - V_dc)^0.5
(V_rms² - V_dc²)^0.5

⇒ A system has 12 poles and 2 zeros. Its high frequency asymptote in its magnitude plot has a slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The efficiency of detection is
0.34
0.555
0.688
0.847

⇒ Which of the following is a valid expression in FORTRAN 77?
B * - 3
B * (- 3)
B * * - 3
B * + 2

⇒ The PSD and the power of a signal g(t) are respectively S_g(ω) and P_g, the PSD and the power of signal a.g(t) are respectively
aS²_g (ω) and a²P_g
aS_g² (ω) and aP_g
aS_g (ω) and a²P_g
aS_g (ω) and aP_g

⇒ Which of the following figures is an ideal equivalent circuit of a n-p-n transis
figure A
figure B
figure C
none

⇒ In case of antenna the lower value of Q indicates
higher bandwidth
lower bandwidth
higher distortion
lower distortion

⇒ Choose correct option
var (X + Y) = Var (X) + Var (Y)
var (X - Y) = Var (X) + Var (Y)
var (X + Y) = Var (X) x Var (Y)
Both (a) and (b)

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ Which of the following is not correct?
Voltmeter should have a very high resistance
An ammeter should have a very low resistance
A shunt should have a very low resistance
An electronic voltmeter draws appreciable current from source

⇒ PCM : Quantising Noise :: Transistor :
Partition noise
Shot noise
Whirl
No noise

⇒ An AM wave is given by s(t)_AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is
0.5
0.58
0.3
0.8

⇒ The circuit show in the figure has 4 boxes each described by inputs P, Q, R and outputs y, z
4 bit adder giving P + Q
4 bit subtractor P - Q
4 bit subtractor Q - P
4 bit adder P + Q + R

⇒ For addition and subtraction operations, phasors
must be represented in polar form
must be represented in rectangular form
may be represented in any form
none of the above

⇒ Given I_s = 20 A, V_s = 20 V, the current I in the 3 Ω resistance is give
0.166666666666667
0.333333333333333
0.0833333333333333
16 A

⇒ Transconductance characteristics of JFET depict the relation between
I_D and V_GS for different value of V_DS
I_D and V_DS for different value of V_GS
V_GS and V_DS for different values of I_D
V_DS and I_D for different values of V_GS

⇒ Which of the following is the main difference between waveguide and transmission line?
Waveguides cannot be coupled to coaxial lines
Waveguides have no standing wave ratio
Transmission line does not suffer from the effect of low cut off frequency
Waveguides are not distributed like transmission lines

⇒ The efficiency of a direct radiating cone type loudspeaker is about
0.05
0.2
0.5
0.8

⇒ When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications
22 K, ± 11%, 1/2 Ω
22 K, ± 5.5%, 1/2 Ω
22 K, ± 5.5%, 1/8 Ω
none of these

⇒ If an admittance Y(s) has a term Ks, the realization would give
an inductance of value K
a resistance of value K
a capacitance of value K
either (a) or(c)

⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m²
716 m²
7.16 m²
71.6 m²

⇒ An amplifier has to amplify pulses of 1 H-s duration. The minimum bandwidth of amplifier must be
10 kHz
10 MHz
1 kHz
1 MHz

⇒ Which of the following insulating material is restricted to temperatures below 100°C?
Micanite
Asbestos
Teflon
Polythene

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ In a 3 phase full wave regulator feeding resistance load connected in star, the possible range of firing angle a is
0 ≤ a ≤ 180°
0 ≤ a ≤ 150°
0 ≤ a ≤ 120°
0 ≤ a ≤ 90°

⇒ Two 2 port circuits are connected cascaded. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters