Question is ⇒ The hexadecimal number 5 F is equal to binary number, Options are ⇒ (A) 1010011, (B) 1011001, (C) 1010101, (D) 1011111, (E) , Leave your comments or Download question paper.

Question is ⇒ The hexadecimal number 5 F is equal to binary number, Options are ⇒ (A) 1010011, (B) 1011001, (C) 1010101, (D) 1011111, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The hexadecimal number 5 F is equal to binary number
A.	1010011 [Wrong Answer]
B.	1011001 [Wrong Answer]
C.	1010101 [Wrong Answer]
D.	1011111 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which group of instructions is used to change sequence of operations in a computer program?
Data transfer group
Branch group
Arithmetic group
Logic group

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32

⇒ A capacitor used for power factor correction in single- phase circuit decreases
the power factor
the line current
both the line current and the power factor
the line current and increases power factor

⇒

Match the following:

	List I (Symbol in Java comparison operator)		List II (Meaning)
A.	= =	1.	Greater than or equal to
B.	! =	2.	Equal
C.	> =	3.	Not equal

A-1, B-2, C-3
A-3, B-2, C-1
A-1, B-3, C-2
A-2, B-3, C-1

⇒ Special circuits using neon tubes, contact relays and capacitors are used in many domestic appliances. The role of capacitor in figure i
reduce power loss
function as resistor when relay is on
delay the operation of the contact relay after switching on
open circuit the relay terminals

⇒ In figure, i(t) is a unit step current. The steady state value of v(t
2 V
3 V
6 V
9 V

⇒ In which of these is reverse recovery time nearly zero?
Zener diode
Tunnel diode
Schottky diode
PIN diode

⇒ In a solar cell, the photovoltaic voltages is the voltage at which the resultant current is
positive
zero
negative
rated current

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒ PAL stands for
Phase Attenuation by Line
Phase Alternation by Line
Parabolic Alternation by Line
Picture Alternation by Line

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ Which of the following oscillator is generally not used at VHF?
Colpitts oscillator
Clapp oscillator
Armstrong oscillator
Ultra Audio oscillator

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ When a semi-conductor is doped, its electrical conductivity
increases
decreases in the direct ratio of the doped material
decreases in the inverse ratio of the doped material
remains unaltered

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region

⇒ The ratio of tangential component of electric field at the surface of a conductor and the linear current density resulting from this field is __________ impedance
characteristic
critical
surface
polarizing

⇒ For very low frequencies, v₀/v_i in the given figure eq
1
0
∞
0.5

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ Current chopping leads to
over voltage
over current
both over voltage and over current
either over voltage or over current

⇒ In figure the total inductance of the circui
L₁ + L₂
L₁ + L₂ + M
L₁ + L₂ + 2M
L₁ + L₂ + M

⇒ Saturation region of a JFET is also known as
source region
analog region
pinch off region
ohmic region

⇒ Which of the following does not use the principle of change in inductance?
LVDT
Inductance displacement transducer
Strain gauge
Reluctance pick up

⇒ If f(t) = 1, F(jω) = 2p δ(ω).
TRUE
FALSE

⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω

⇒ In the expression b = 2.1 / 1.2 * 3.1 + 3 / 7.1 * 6 which operation would have the first priority in C?
2.1 / 1.2
1.2 * 3.1
2.1 / 1.2 * 3.1
3 / 7.1

⇒ In which device does the extent of light controls the conduction
photovoltaic cell
photo electric relay
LED
photo sensitive device

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ In a hi-fi system the frequency response over the audio frequency range should be within
± 10 dB
5 dB
2 dB
1 dB

⇒ S is closed for a long time and steady state is reached. S is opened at t(0^-). The voltage marked V is V₀ at t = 0⁺ and V_f at t = ∞. Then value of V₀ and V_f are respecti
8, 8
0, 1
4, 0
4, 8