Question is ⇒ The general purpose register code for accumulator in 8085 is, Options are ⇒ (A) 111, (B) 0, (C) 1, (D) 1111, (E) , Leave your comments or Download question paper.

Question is ⇒ The general purpose register code for accumulator in 8085 is, Options are ⇒ (A) 111, (B) 0, (C) 1, (D) 1111, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The general purpose register code for accumulator in 8085 is
A.	111 [Correct Answer]
B.	0 [Wrong Answer]
C.	1 [Wrong Answer]
D.	1111 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In an n channel JFET
I_D, I_S and I_G are considered positive when flowing into the transistor
I_D and I_S are considered positive when flowing into transistor and I_G is considered positive when flowing out of it
I_D, I_S, I_G are considered positive when flowing out of transistor
I_S and I_G are considered positive when flowing into transistor and I_D is considered positive when flowing out of it

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high

⇒ In p channel JFET, V_GS is positive.
TRUE
FALSE

⇒ A digital clock uses __________ chip
SSI
LSI
VLSI
MSI

⇒ In windows the middle button of mouse is not used.
TRUE
FALSE

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒ Which of the following are included in the architecture of a computer?

Addressing modes, CPU
Instruction set, data formats
Secondary memory, operating system

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
3 only

⇒

Match the following:

	List I (Types of transmission structure)		List II (Modes of propagation)
A.	Strip line	1.	Quasi TEM
B.	Hollow rectangular waveguide	2.	Pure TEM
C.	Microstrip	3.	TE/TM
D.	Corrugated waveguide	4.	Hybrid

A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4
A-4, B-3, C-1, D-2

⇒ Which of the following transducers is most suitable for monitoring continuous variations in very fine thickness of a material?
Diaphragm
Capacitor
L.V.D.T.
Piezoelectric crystal.

⇒ It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude
will increase
will decrease
will remain constant
will reduce to negligible value

⇒ An R-L series circuit has R = 5 Ω and L = .01 H. It is fed by ac 50 Hz supply. The rms current in the circuit is 5 A. The active power supplied by the source is
25 W
50 W
125 W
250 W

⇒ Pirani gauge is used to measure
very low pressure
high pressure
pressure in the range of 1 atmosphere
fluid flow

⇒ The internal impedance of a source is 3 + j 4 Ω. It is desired to supply maximum power to a resistive load. The load resistance should be
3 Ω
4 Ω
7 Ω
5 Ω

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ If operator 'a' = 1 ∠120° then (1 - a) =
3
3 ∠ - 30°
3 ∠ + 30°
3 ∠60°

⇒ It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of
2
4
8
16

⇒ Which of the following commutation methods is the overall circuit under damped?
Class A
Class B
Class C
Both class A and Class B

⇒ Positive feedback is mainly used in
oscillators
thyristors
voltage regulators
both (a) and (b)

⇒ In intrinsic semiconductor, the fermi level
lies at the centre of forbidden energy gap
is near the conduction band
is near the valence band
may be anywhere in the forbidden energy gap

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ Identify which of the following is not a tree of the graph shown in fi
bcgh
defg
abfg
aegh

⇒ In laboratory experiment the output from reflex klystron is moderated by square wave because
it is easy to generate a square wave
crystal diode operates in square law region of i-v characteristics
it prevents frequency modulation
detector circuit is less complicated

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒ In figure the zener has a resistance of 5 ohms. As the load resistance is varied, the output vol
will remain constant at 12 V
will vary between 12.05 and 12.65 V
will vary from 10 to 20 V
will remain constant at 12.05 V

⇒ In radar display system PPI stands for
Pulse Position Indicator
Plan Position Indicator
Phase Position Indicator
Point Position Indicator

⇒

Assertion (A): A tree of graph contains all the nodes of the graph.

Reason (R): The number of links is always less than the number of tree branches.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Equipment using BCD numbers
pocket calculators
electronic counter
digital voltmeters
all of the above