Question is ⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as, Options are ⇒ (A) A ⊕ B ⊕ D, (B) A ⊕ B ⊕ E, (C) A ⊕ E, (D) A ⊕ E, (E) , Leave your comments or Download question paper.

Question is ⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as, Options are ⇒ (A) A ⊕ B ⊕ D, (B) A ⊕ B ⊕ E, (C) A ⊕ E, (D) A ⊕ E, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as
A.	A ⊕ B ⊕ D [Wrong Answer]
B.	A ⊕ B ⊕ E [Wrong Answer]
C.	A ⊕ E [Wrong Answer]
D.	A ⊕ E [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ac circuit has an impedance of (3 + j6) ohm for fundamental. The impedance for fifth harmonic is
(15 + j 30) Ω
(15 + j 6) Ω
(3 + j 30) Ω
(3 + j 1.2) Ω

⇒

Match the following:

	List I (Circuit)		List II (Characteristics)
A.	Darlington pair	1.	uses pnp and npn transistors used as power amplifier
B.	CB amplifier	2.	Voltage gain nearly 1 and high input impedance
C.	Cascade amplifier	3.	low input impedance used for high frequency isolation

A-1, B-2, C-3
A-2, B-3, C-1
A-2, B-1, C-3
A-3, B-1, C-2

⇒ In figure, capacitor is used to develop pulses of short duration and large duty cycle across R₂ when switch is closed. Which of the following combinations is best sui
R₁ and R₂ large but C small
R₁ and R₂ small but C large
R₁ and C large and R₂ small
R₂ and C large but R₁ small

⇒ Which of the following parameters is negligible in transmission lines?
R
L
C
G

⇒ Each kilometer of travel in electromagnetic radiation means a time delay of
330 μs
33 μs
3.3 μs
0.33 μs

⇒ In the figure shown, A₁, A₂, A₃ are identical Ammeters. If A₁ and A₃ read 5 and 13 A respectively, reading of A₂ wil
8
13 A
18
0

⇒ For the discrete time system of the given fig
y_k - 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k - 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k

⇒

Assertion (A): Microprocessors 8086 and 8088 are very similar in organisation and have identical instruction sets.

Reason (R): If clock speed is same the execution time of 8088 and 8086 are exactly equal.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statement is correct?
FET and junction transistor both are unipolar
FET and junction transistor both are bipolar
The FET is bipolar, while junction transistor are unipolar
The FET is unipolar, while junction transistor are bipolar

⇒ A computer memory is an ordered sequence of storage cells.
TRUE
FALSE

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A transistor has

collector
emitter
base

In a N-P-N transistor the electron flow into the transistor at
I only
II only
II and III only
I and II only

⇒ With 2's complement representation, the range of values that can be represented on the data bus of an 8 bit microprocessor is given by
-128 to 127
-128 to +128
-127 to 128
-256 to 256

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ The response to sinusoidal excitation can be found by
settings s = jω in the network function
settings s = - jω in the network function
taking inverse transform of network function
none of the above

⇒ A balanced modulator is used in the generation of which of the following?
DSB-SC signal
FM signal
PM signal
PAM signal

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ Which of following is recursive system?
y(n - 1)
y(n + 1)
y(n)
y(n) + y(n + 1)

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒ The depth of modulation is doubled in FM system then, the power transmitted
increase by factor of 2
increase by factor of 3
increase by factor of 2
none of the above

⇒ In a current transformers
the number of turns in primary and secondary windings are nearly equal
the number of primary turns is very small as compared to number of secondary turns.
the number of secondary turns is very small as compared to the number of primary turns
either (a) or (c).

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
5/δ
Intermediate
δ/5
δ

⇒ A radar receiver has a noise figure of 10 dB at 300 K having a bandwidth of 2.5 MHz. The minimum power it can receive is
3.45 x 10^-15 W
1.38 x 10^-15 W
7.5 x 10^-15 W
93.15 x 10^-15 W

⇒ A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is
0.2
0.5
1
2

⇒

JCOKE
8
11
16
20



⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ Match the following:
 List I  List II 
A. CTFS 1. Periodic
B. DTFS 2. Non-periodic
C. CTFT   
D. DTFT   

A-2, B-1, C-2, D-2
A-2, B-1, C-2, D-1
A-1, B-2, C-2, D-2
A-1, B-2, C-2, D-1

⇒ A-P type material has an acceptor ion concentration of 1 x 10¹⁶ per cm³. Its intrinsic carrier concentration is 1.48 x 10¹⁰/ cm. The hole and electron mobilities are 0.05m²/V-sec and 0.13 m²/V-sec respectively calculate the resistivity of the material
12.5 Ω-cm
1.25 Ω-cm
0.125 Ω-cm
125 Ω-cm

	List I		List II
A.	CTFS	1.	Periodic
B.	DTFS	2.	Non-periodic
C.	CTFT
D.	DTFT









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	



    
	StudySite.org is world's best online study provider, Copyright © 2023 by 
StudySite.org All Rights Reserved