Question is ⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are, Options are ⇒ (A) Triple Transistor Logic and Chip Metal Oxide Semiconductor, (B) Tristate Transistor Logic and Chip Metal Oxide Semiconductor, (C) Transistor Transistor logic and Complementary Metal Oxide Semiconductor, (D) Trisate Transistor Logic and Complementary Metal Oxide Silicon, (E) , Leave your comments or Download question paper.

Question is ⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are, Options are ⇒ (A) Triple Transistor Logic and Chip Metal Oxide Semiconductor, (B) Tristate Transistor Logic and Chip Metal Oxide Semiconductor, (C) Transistor Transistor logic and Complementary Metal Oxide Semiconductor, (D) Trisate Transistor Logic and Complementary Metal Oxide Silicon, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The full form of the abbreviations TTL and CMOS in reference to logic families are
A.	Triple Transistor Logic and Chip Metal Oxide Semiconductor [Wrong Answer]
B.	Tristate Transistor Logic and Chip Metal Oxide Semiconductor [Wrong Answer]
C.	Transistor Transistor logic and Complementary Metal Oxide Semiconductor [Correct Answer]
D.	Trisate Transistor Logic and Complementary Metal Oxide Silicon [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (FET Parameters)		List II (Typical Values)
A.	g_m for JFET	1.	25 kW
B.	r_d for JFET	2.	0.01 siemen
C.	r_d for MOSFET	3.	0.5 mW
D.	g_g for JFET	4.	10^-8 siemen

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-4, B-2, C-3, D-1
A-4, B-3, C-2, D-1

⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
f times/sec
0.5 f times/sec
0.25 f times/sec
2 f times/sec

⇒ A multiple emitter transistor has many emitters and collectors.
TRUE
FALSE

⇒

Assertion (A): In an RC coupled amplifier the junction capacitances can be neglected at low frequencies but not at high frequencies

Reason (R): Capacitive reactance is inversely proportional to frequency.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): Shunt of an ammeter has a low resistance.

Reason (R): Shunt may be connected in series or in parallel with ammeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following frequency is likely to be associated with AM radio broadcast?
1000 kHz
100 MHz
500 MHz
10 GHz

⇒ When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
P_t = 1.5 P_c
P_t = 2.5 P_c
P_t = 2
P_t = 22 P_c

⇒ The total insulation resistance consists of insulation volume resistance and surface leakage resistance.
TRUE
FALSE

⇒ The number of spectral component of impulse wave is
1
0
2
∞

⇒ In a highly capacitive circuit the
apparent power is equal to the actual power
reactive power is more than the apparent power
reactive power is more than the actual power
actual power is more than its reactive power

⇒ The amplitude of a random signal uniformly distributed between - 5 V and
0.0333 V
0.05 V
0.0667 V
0.10 V

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒

Assertion (A): EM waves are attenuated as they travel outward from a source

Reason (R): Both field intensity and power density follow inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒ Which of the following are true for relative dielectric constant?

It is dimensionless.
It is equal to 1 for vacuum.
It is equal to 1 for all substances.

1 and 2 only
2 and 3 only
1 and 3 only
1, 2 and 3

⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC

⇒ For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input
0°
90°
-90°
± 180°

⇒ A dipole antenna of λ/8 length has an equivalent total loss resistance of 1.5 Ω. The efficiency of the antenna is
0.0089159
0.089159
0.89159
8.9159

⇒

Match the following:

	List I (Bit Pattern)		List II (Register pairs)
A.	00	1.	SP
B.	01	2.	B-C
C.	10	3.	D-E
D.	11	4.	H-L

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ Above ferroelectric curie temperature, spontaneous polarization in ferroelectric materials becomes stronger.
TRUE
FALSE

⇒ Which of the following periodic waveforms will have only odd harmonics of sinusoidal wavef
1 and 2
1 and 3
1 and 4
2 and 4

⇒

Assertion (A): A photovoltaic cell is greatly affected by temperature.

Reason (R): Both germanium and silicon can be used for photovoltaic cells.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): Doping level in extrinsic semiconductors is very small.

Reason (R): Additional of impurity in the ratio of 1 part in 10⁸ parts increases the number of charge carriers by about 20.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ With JFETs cascade means
a common source driving a common gate connection
a common gate driving a common source connection
two FETs connected in parallel
none of the above

⇒ If a RAM has 34 bits in its MAR and 16 bits in its MDR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ The mean life time of carrier may range from 10^-9 seconds to hundreds of μ-seconds.
TRUE
FALSE

⇒ The parameter A of a two port network is equal to
V₂/V₁ with I₁ = 0
V₁/I₂ with V₂ = 0
I₁/I₂ with V₂ = 0
V₁/V₂ with I₂ = 0

⇒ If a sheet of a mica is inserted between the plates of an air capacitor, the capacitance
will increase
will return the same
will decrease
may increase or decrease