Question is ⇒ The frequency of voltage generated, in case of generators, can be increased by, Options are ⇒ (A) using reactors, (B) increasing the load, (C) adjusting the governor, (D) reducing the terminal voltage, (E) none of the above, Leave your comments or Download question paper.

Question is ⇒ The frequency of voltage generated, in case of generators, can be increased by, Options are ⇒ (A) using reactors, (B) increasing the load, (C) adjusting the governor, (D) reducing the terminal voltage, (E) none of the above, Leave your comments or Download question paper. Previous question Next question


Q1.	The frequency of voltage generated, in case of generators, can be increased by
A.	using reactors [Wrong Answer]
B.	increasing the load [Wrong Answer]
C.	adjusting the governor [Correct Answer]
D.	reducing the terminal voltage [Wrong Answer]
E.	none of the above [Wrong Answer]
View Answer 11 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The loads on distributors systems are generally
balanced
unbalanced
either of the above
none of the above

⇒ A synchronous condenser is generally installed at the of the ____ transmission line
receiving end
sending end
middle
none of the above

⇒ Constant voltage transmission entails the following disadvantage
large conductor area is required for same power transmission
short-circuit current of the system is increased
either of the above
none of the above

⇒ Which of the following can be used for bus-bars ?
Tubes
Rods
Bars
Any of the above

⇒ The effective resistance of a conductor will be the same as 'ohmic resistance' when
power factor is unity
current is uniformly distributed in the conductor cross-section
voltage is low
current is in true sine wave form

⇒ As compared to a 2-wire D.C. distributor, a 3-wire distributor with same maximum voltage to earth uses only
31.25 percent of copper
33.3 percent of copper
66.7 percent of copper
125 percent of copper

⇒ To increase the capacity of a transmission line for transmitting power which of the following must be decreased ?
Capacitance
Line inductance
Voltage
All of the above

⇒ The distributors for residential areas are
single phase
three-phase three wire
three-phase four wire
none of the above

⇒ Pin type insulators are generally not used for voltages beyond
1 kV
11 kV
22 kV
33 kV

⇒ Most of the high voltage transmission lines in India are
undergound
overhead
either of the above
none of the above

⇒ The purpose of using a booster is to
increase current
reduce current
reduce voltage drop
compensate for voltage drop

⇒ A.C.S.R. conductor having 7 steel stands surrounded by 25 aluminium conductors will be specified as
25/7
50/15
7/25
15/50

⇒ The operating voltage of extra high tension cables is upto
66 kV
11 kV
33 kV
66 kV

⇒ Skin effect is proportional to
(conductor diameter)⁴
(conductor diameter)³
(conductor diameter)²
(conductor diameter)^1/2

⇒ Which of the following faults is most likely to occur in cables ?
Cross or short-circuit fault
Open circuit fault
Breakdown of cable insulation
All of the above

⇒ A circuit is disconnected by isolators when
line is energized
there is no current in the line
line is on full load
circuit breaker is not open

⇒ The power transmitted will be maximum when
corona losses are minimum
reactance is high
sending end voltage is more
receiving end voltage is more

⇒ Which of the following is the source of heat generation in the cables ?
Dielectric losses in cable insulation
IR losses in the conductor
Losses in the metallic sheathings and armourings
All of the above

⇒ On which of the following does the size of a feeder depend ?
Voltage drop
Voltage
Frequency
Current carrying capacity

⇒ Poles which carry transformers are usually
circular
I-type
A-type
H-type

⇒ As compared to cables, the disadvantage of transmission lines is
inductive interference between power and communication circuits
exposure to lightning
exposure to atmospheric hazards like smoke, ice, etc.
all of the above

⇒ Which of the following cause transient disturbances ?
Faults
Load variations
Switching operations
Any of the above

⇒ Large industrial consumers are supplied electrical energy at
400 V
11 kV
66 kV
400 kV

⇒ The phenomenon of rise in voltage at the receiving end of the open-circuited or lightly loaded line is called the
Seeback effect
Ferranti effect
Raman effect
none of the above

⇒ By which of the following methods the protection against direct lightning strokes and high voltage sweep waves is provided ?
Lightening arresters
Ground wire
Lightening arresters and ground wires
Earthing of neutral

⇒ Galvanised steel wire is generally used as
stay wire
earth wire
structural components
all of the above

⇒ Overhead system can be designed for operation upto
11 kV
33 kV
66 kV
400 kV

⇒ Which of the following equipment is used to limit short-circuit current level in a substation ?
Isolator
Lightning switch
Coupling capacitor
Series reactor

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ In a D.C. 3-wire distribution system, balancer fields are cross-connected in order to
boost the generated voltage
balance loads on both sides of the neutral
make both machines run as unloaded motors
equalize voltages on the positive and negative outers