Question is ⇒ The form factor is the ratio of, Options are ⇒ (A) Peak value to r.m.s. value, (B) r.m.s. value to average value, (C) Average value to r.m.s. value, (D) None of these, (E) , Leave your comments or Download question paper.

Question is ⇒ The form factor is the ratio of, Options are ⇒ (A) Peak value to r.m.s. value, (B) r.m.s. value to average value, (C) Average value to r.m.s. value, (D) None of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The form factor is the ratio of
A.	Peak value to r.m.s. value [Wrong Answer]
B.	r.m.s. value to average value [Correct Answer]
C.	Average value to r.m.s. value [Wrong Answer]
D.	None of these [Wrong Answer]
View Answer 13 -6 Explanation:- Answer : B Discuss it below : Admin Ajuni Said on 2024-01-10 22:13:39 For an oscillatory circuit with logarithmic decrement of 0.1, the number oscillations in a wave train, before the amplitude of the current has fallen to 1% of the initial value would be !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a sine wave with peak value I_max the r.m.s. value is
0.5 I_max
0.707 I_max
0.9 I_max
1.414 I_max

⇒ The time constant of a series R-C circuit is given by
R/C
RC²
RC
R²C

⇒ The power consumed in a circuit element will be least when the phase difference between the current and voltage
180°
90°
60°
0°

⇒ A network is said to be non-linear if it does not satisfy
Homogeneity condition
Superposition condition
Both (A) and (B)
Associative condition

⇒ The power factor of incandescent bulb is
0.8 lagging
0.8 leading
Unity
Zero

⇒ Which of the following waves has the highest value of peak factor '?
Square wave
Sine wave
Half wave rectifier sine wave
Triangular wave

⇒ Capacitors for power factor correction are rated in
kW
kVA
kV
kVAR

⇒ Which of the following statement is incorrect ?
Resistance is a passive element
Voltage source is an active element
Conductance is a passive element
Current source is a passive element

⇒ In A.C. circuit laminated iron is invariably used in order to
Reduce eddy current loss
Increase heat radiation
Make assembly cheap and easier
Reduce circuit permeability

⇒ The power factor at resonance in RLC parallel circuit is
Zero
0.08 Lagging
0.8 Leading
Unity

⇒ In a R-L-C series circuit if voltage V across the circuit is reduced to half the current I will change to
2 I
I/2
3/4 I
5/8 I

⇒ In a circuit containing R, L and C, power loss can take place
C only
L only
R only
All of the above

⇒ The shunt element in a band pass filter is
Capacitive
Inductive
Parallel combination of L and C
Series combination of L and C

⇒ Power factor of electric bulb is
Zero
Lagging
Leading
Unity

⇒ At half power points of a resonance curve, the current is____ times the maximum current.
1/2
1/ √2
√2
2

⇒ All the rules and laws of D.C. circuit also supply to A.C. circuit containing
Capacitance only
Inductance only
Resistance only
All above

⇒ The value of operator j2 is equal to
Zero
+1
-1
√-1

⇒ For the full wave rectified sine wave the r.m.s. value is
0.707 I_max
0.636 I_max
0.318 I_max
Zero

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.
Impedance
Susceptance
Quality factor
Selectivity

⇒ At____ frequencies the parallel R-L circuit behaves as purely resistive.
Low
Very low
High
Very high

⇒ At very low frequencies a series R-C circuit behaves as almost purely____
Resistive
Inductive
Capacitive
None of these

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees
90
60
45
30

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates
Low efficiency
High power factor
Unity power factor
Maximum Load current

⇒ In a series resonant circuit, the impedance of the circuit is
Minimum
Maximum
Zero
None of the above

⇒ While drawing vector diagram for a series circuit the reference vector is
Voltage
Current
Power
Phase angle

⇒ The power is measured in terms of decibles in case of
Electronic equipment
Transformers
Current transformers
Auto-transformers

⇒ In A.C. circuit the power curve is a sine wave having
Double the frequency of voltage
Same frequency as that of voltage
Half the frequency of the voltage
None of these

⇒ The safest value of current the human body can carry for more than 3 second is
4 mA
9 mA
15 mA
25 mA

⇒ Selectivities of different resonance circuits are compared in terms of their
Impedances
Reactances
Frequencies
Band widths

⇒ Skin effect occurs when a conductor carries current at____ frequencies.
Very low
Low
Medium
High