Question is ⇒ The forbidden energy gap in semiconductors, Options are ⇒ (A) is always zero, (B) lies just below the valence band, (C) lies between the valence band and the conduction band, (D) lies just above the conduction band, (E) , Leave your comments or Download question paper.

Question is ⇒ The forbidden energy gap in semiconductors, Options are ⇒ (A) is always zero, (B) lies just below the valence band, (C) lies between the valence band and the conduction band, (D) lies just above the conduction band, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The forbidden energy gap in semiconductors
A.	is always zero [Wrong Answer]
B.	lies just below the valence band [Wrong Answer]
C.	lies between the valence band and the conduction band [Correct Answer]
D.	lies just above the conduction band [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 16 bit counter type ADC uses 1 MHz clock then its maximum conversion time is __________ .
16 μs
15 ms
6.6 ms
66 ms

⇒ Gold is often diffused into silicon P-N junction devices to
increase recombination rate
reduce recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The V_o of the op-amp circuit shown in the give
11 V_i
10 V_i
V_i
zero

⇒ LVDT is a
pressure transducer
displacement transducer
velocity transducer
acceleration transducer

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ In a pneumatic bellows
the input surface, output surface and side walls are corrugated
the input surface and output surface are flat but the side walls are corrugated
the input surface and side walls are flat but the output surface is corrugated
the input surface and output surface are corrugated but the side walls are flat

⇒

Assertion (A): In root locus the breakaway and break in points either lie on real axis or occur in complex conjugate pairs.

Reason (R): All root locus asymptotes intersect on real axis.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b would always be in phase
V_a may lag or lead V_b

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ 23.6₁₀ = __________ ₂
11111.1001
10111.1001
111.101
10111.1

⇒ In the fabrication of n-p-n transistor in an IC, the buried layer on the P-type substrate is
P⁺ -doped
n⁺ -doped
used to reduce the parasitic capacitance
located in the emitter region

⇒ Which of the following statements is incorrect?
Ideal voltage source is one whose internal resistance is zero
Ideal voltage source is one whose internal conductance is zero
Ideal voltage source is one whose generated voltage is equal to the available terminal voltage
Ideal current source is one whose internal conductance is zero

⇒ The time constant of a series R-C circuit is given by
R/C
RC²
RC
R²C

⇒ The phase angle curve of G(jω) H(jω) can be drawn
by adding the phase angle curves of individual factors
by subtracting the phase angle curves of individual factors
by multiplying the phase angle curves of individual factors
by dividing the phase angle curves of individual factors

⇒ In sound recording the degree of pre-emphasis is about 6 dB/ octave.
TRUE
FALSE

⇒ Poynting vector is associated with
flux in magnetic field
power flow in electrostatic field
current in electrostatic field
charge in electrostatic field

⇒ The number of accumulators in 6800 are
2
3
1
4

⇒ Power gain of an antenna in a given direction is the ratio of
average power to maximum power
radiation intensity in that direction to the total input radiated power
radiation intensity in that direction to the average radiated power
none of the above

⇒ The circuit shown in the figure
positive logic OR circuit
negative logic OR circuit
positive logic AND circuit
negative logic AND circuit

⇒ Examine the circuit of figure and the following statem
1, 2, 3
1, 2
1 only
2 and 3

⇒ An MTI radar operating at 5 GHz has a PRF of 800 pps. The lowest blind speed is
48 m/s
96 m/s
192 m/s
24 m/s

⇒ The charges between a hollow and solid metal spheres reside
through out in both
on outer surface in hollow and through out in solid
on the outer surface in both
none of the above

⇒ In Pulse Code Modulation system
large bandwidth is required
quantising noise can be overcome by companding
quantising noise can be reduced by decreasing the number of standard levels
suffers from the disadvantage of its incompatibly with TDM

⇒ If e is the charge of an electron, R is the radius of its orbit and ω is the angular velocity of electron, the magnetic dipole moment μ_m of the orbit is |μ_m| = eωR².
TRUE
FALSE

⇒ A multiple emitter transistor has many emitters and collectors.
TRUE
FALSE

⇒ Fundamental mode is another name for
level operation
pulse operation
clock operation
none of these